Methods of overlapping closed joints in friction stir welding of thin wall structures made of aluminium alloys

被引：0
作者：
Velichko O.V. [1 ]
Ivanov S.Y. [2 ]
Karkhin V.A. [2 ]
Khomich P.N. [2 ]
Lopota V.A. [3 ]
Makhin I.D. [4 ]
机构：
[1] Centre for Laser Technologies, St. Petersburg
[2] St. Petersburg State Polytechnic University, St. Petersburg
[3] Joint Rocket and Space Company, Moscow
[4] S.P. Korolev Rocket and Space Corporation “Energiya”, Moscow
来源：
Welding International | 2016年 / 30卷 / 10期
关键词：
Al–Mg–Sc alloy; Friction welding with mixing; heterogeneous; mechanical properties; microstructure; output orifice removal;
D O I：
10.1080/09507116.2016.1148406
中图分类号：
学科分类号：
摘要：
Three methods of completing closed (circular and annular) welded joints in welding the 1570C alloy of an Al–Mg–Sc system with a thickness of 11 and 35 mm (using the output wedge, a tool with a moving tip, friction welding) are discussed. The range of double stirring (the beginning to end of the welded joint) has a heterogeneous microstructure and mechanical properties. The distributions of the hardness of the weld metal after the first and second stirring cycle are similar if the working length of the tip is the same, and greatly differ if the working length of the tool used for the second pass is variable (as in welding with a moving tip). The ratio of the tensile strength of the welded joint and the parent metal is not lower than 0.9, which is higher than in arc welding. It is shown that the three methods of completing the closed joints can be used in practice. © 2016 Informa UK Limited, trading as Taylor & Francis Group.
引用
收藏
页码：797 / 801
页数：4
相关论文
共 6 条
  • [1] Ding R., Oelgoetz P.A., Mechanical properties analysis in the retracted pin–tool (RPT) region of friction stir welding (FSW) aluminium–lithium 2195 alloy, (1999)
  • [2] Thompson B., Et al., Friction stir welding of thick section aluminium for military vehicle applications, (2012)
  • [3] Velichko O.V., Et al., Friction stir welding of thick plates of Al–Mg–Sc alloy, Svar. Proiz, 8, pp. 19-23, (2015)
  • [4] Leal R.M., Loureiro A., Effect of overlapping friction stir welding passes on the quality of welded aluminium alloys, Mater. Des, 29, pp. 982-991, (2008)
  • [5] Brown R., Et al., Multipass friction stir welding in alloys 7050–T7451. Effect on the weld response variables and on weld properties, Mater. Sci. Eng. A, 513-514, pp. 115-121, (2009)
  • [6] Candra J., Et al., Effect of overlapping direction in multipass friction stir processing, Mater. Sci. Eng. A, 528, pp. 5592-5599, (2011)
1