Effect of plating parameters on Ni-P-Al2O3 coatings deposited by ultrasonic electroless deposition

被引：0

作者：

Liang, Gui-Qiang ^{[1
,2
]}

Zhou, Xiao-Qin ^{[2
]}

机构：

[1] College of Electrical Engineering, Binzhou Polytechnic

[2] College of Mechanical Science and Engineering, Jilin University

来源：

Gongneng Cailiao/Journal of Functional Materials | 2014年 / 45卷 / 11期

关键词：

Effect; Plating parameters;

D O I：

10.3969/j.issn.1001-9731.2014.11.029

中图分类号：

学科分类号：

摘要：

In order to improve the comprehensive properties of stainless steel, Ni-P-Al2O3 coatings were successfully prepared by ultrasonic electroless deposition on the surface of 304 stainless steel. The plating rate, microhardness and composition of Ni-P-Al2O3 composite coatings were investigated by using electronic analytical balance, microhardness tester and X-ray diffraction. The results indicate that when the Al2O3 concentration was 2 g/L, the plating rate and microhardness of Ni-P-Al2O3 coatings were 8.7 μm/h and 760 Hv, respectively. While bath temperature maintained at 85°C, the plating rate and microhardness of the coatings were 8.4 μm/h and 747 Hv, respectively. There were Ni, Ni3P and Al2O3 in Ni-P-Al2O3 coatings.

引用

页码：11137 / 11139

页数：2

共 7 条

[1] Xu Y., Zou Y., Luan T., Electrochemical characterization and evaluation of electroless coating porosity, Journal of Functional Materials, 44, 6, pp. 902-905, (2013)
[2] 36, 2, pp. 101-104, (2013)
[3] 35, 2, pp. 189-195, (2011)
[4] Xia F.F., Liu C., Wang F., Et al., Preparation and characterization of nano Ni-TiN coatings deposited by ultrasonic electrodeposition, Journal of Alloys and Compounds, 490, pp. 431-435, (2010)
[5] 27, 1, pp. 4-7, (2005)
[6] Ma C.Y., Liang G.Q., Zhu Y.Y., Et al., Preparation and corrosion assessment of electrodeposited Ni-SiC composite thin films, Ceramics International, 40, pp. 3341-3346, (2014)
[7] Xia F.F., Liu C., Ma C.H., Et al., Preparation and corrosion behavior of electrodeposited Ni-TiN composite coatings, Int Journal of Refractory Metals and Hard Materials, 35, pp. 295-299, (2012)

← 1 →