Deformation behavior of Mg-Y-Ni alloys containing different volume fraction of LPSO phase during tension and compression through in-situ synchrotron diffraction

被引:7
作者
Wu, S. Z. [1 ]
Chi, Y. Q. [2 ]
Garces, G. [3 ]
Zhou, X. H. [4 ]
Brokmeier, H. G. [4 ]
Qiao, X. G. [1 ]
Zheng, M. Y. [1 ]
机构
[1] Harbin Inst Technol, Sch Mat Sci & Engn, Harbin 150001, Peoples R China
[2] Guangdong Univ Technol, Sch Electromech Engn, Guangzhou 510006, Peoples R China
[3] CSIC, CENIM, Dept Phys Met, Ave Gregorio del Amo 8, Madrid 28040, Spain
[4] Tech Univ Clausthal, Inst Mat Sci & Engn, Agricolastr 6, D-38678 Clausthal Zellerfeld, Germany
基金
中国国家自然科学基金;
关键词
Mg-Y-Ni alloys; LPSO phase; In-situ synchrotron diffraction; Micro-yielding; Tensile-compression asymmetry; Strain hardening; ZN-Y; MECHANICAL-PROPERTIES; HIGH-STRENGTH; TEXTURE; MICROSTRUCTURE; TEMPERATURE;
D O I
10.1016/j.jma.2023.01.013
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
The deformation behavior of the as-extruded Mg-Y-Ni alloys with different volume fraction of long period stacking ordered (LPSO) phase during tension and compression was investigated by in-situ synchrotron diffraction. The micro-yielding, macro-yielding, tension-compression asymmetry and strain hardening behavior of the alloys were explored by combining with deformation mechanisms. The micro-yielding is dominated by basal slip of dynamic recrystallized (DRXed) grains in tension, while it is dominated by extension twinning of non-dynamic recrystallized (non-DRXed) grains in compression. At macro-yielding, the non-DRXed grains are still elastic deformed in tension and the basal slip of DRXed grains in compression are activated. Meanwhile, the LPSO phase still retains elastic deformation, but can bear more load, so the higher the volume fraction of hard LPSO phase, the higher the tensile/compressive macro-yield strength of the alloys. Benefiting from the low volume fraction of the non-DRXed grains and the delay effect of LPSO and gamma' phases on extension twinning, the as-extruded alloys exhibit excellent tension-compression symmetry. When the volume fraction of LPSO phase reaches <^> 50%, tension-compression asymmetry is reversed, which is due to the fact that the LPSO phase is stronger in compression than in tension. The tensile strain hardening behavior is dominated by dislocation slip, while the dominate mechanism for compressive strain hardening changes from twinning in the alpha-Mg grains to kinking of the LPSO phase with increasing volume fraction of LPSO phase. The activation of kinking leads to the constant compressive strain hardening rate of <^> 2500 MPa, which is significantly higher than the tensile strain hardening rate. (c) 2023 Chongqing University. Publishing services provided by Elsevier B.V. on behalf of KeAi Communications Co. Ltd. This is an open access article under the CC BY-NC-ND license ( http://creativecommons.org/licenses/by-nc-nd/4.0/) Peer review under responsibility of Chongqing University
引用
收藏
页码:3631 / 3645
页数:15
相关论文
共 46 条
  • [1] Validating a polycrystal model for the elastoplastic response of magnesium alloy AZ31 using in situ neutron diffraction
    Agnew, S. R.
    Brown, D. W.
    Tome, C. N.
    [J]. ACTA MATERIALIA, 2006, 54 (18) : 4841 - 4852
  • [2] Precipitate strengthening of pyramidal slip in Mg-Zn alloys
    Alizadeh, Reza
    Wang, Jingya
    LLorca, Javier
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2021, 804
  • [3] Microstructure and mechanical properties of extruded Mg-Y-Zn (Ni) alloys
    Bi, Guang Li
    Wang, Yashuo
    Jiang, Jing
    Gu, Jiarui
    Li, Yuandong
    Chen, Tijun
    Ma, Ying
    [J]. JOURNAL OF ALLOYS AND COMPOUNDS, 2021, 881
  • [4] Tension-compression asymmetry of extruded Mg-Gd-Y-Zr alloy with a bimodal microstructure studied by in-situ synchrotron diffraction
    Chi, Y. Q.
    Zhou, X. H.
    Qiao, X. G.
    Brokmeier, H. G.
    Zheng, M. Y.
    [J]. MATERIALS & DESIGN, 2019, 170
  • [5] Twinning behavior and deformation mechanisms of extruded AZ31 Mg alloy
    Chino, Yasumasa
    Kimura, Katsuya
    Mabuchi, Mamoru
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2008, 486 (1-2): : 481 - 488
  • [6] Influence of texture and grain size on work hardening and ductility in magnesium-based alloys processed by ECAP and rolling
    del Valle, J. A.
    Carreno, F.
    Ruano, O. A.
    [J]. ACTA MATERIALIA, 2006, 54 (16) : 4247 - 4259
  • [7] Internal friction and microplastic deformation behavior of pure magnesium processed by equal channel angular pressing
    Fan, G. D.
    Zheng, M. Y.
    Hu, X. S.
    Wu, K.
    Gan, W. M.
    Brokmeier, H. G.
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2013, 561 : 100 - 108
  • [8] Analysis of the Microstructure Role in the Yield Asymmetry of Extruded Mg-LPSO Alloys Using In Situ Diffraction Experiments
    Garces, G.
    Medina, J.
    Perez, P.
    Stark, A.
    Lim, H. K.
    Kim, S.
    Shell, N.
    Adeva, P.
    [J]. JOM, 2022, 74 (07) : 2609 - 2621
  • [9] Effect of precipitation in the compressive behavior of high strength Mg-Gd-Y-Zn extruded alloy
    Garces, G.
    Mathis, K.
    Barea, R.
    Medina, J.
    Perez, P.
    Stark, A.
    Schell, N.
    Adeva, P.
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2019, 768
  • [10] Combination of in-situ diffraction experiments and acoustic emission testing to understand the compression behavior of Mg-Y-Zn alloys containing LPSO phase under different loading conditions
    Garces, G.
    Mathis, K.
    Medina, J.
    Horvath, K.
    Drozdenko, D.
    Onorbe, E.
    Dobron, P.
    Perez, P.
    Klaus, M.
    Adeva, P.
    [J]. INTERNATIONAL JOURNAL OF PLASTICITY, 2018, 106 : 107 - 128