Selected testing for rapid prototyping technology operation

被引：0

作者：

Novakova-Marcincinova, Ludmila ^{[1
]}

Novak-Marcincin, Jozef ^{[1
]}

机构：

[1] Technical University of Košice, Department of Manufacturing Technologies, Prešov

来源：

Applied Mechanics and Materials | 2013年 / 308卷

关键词：

Materials; Rapid prototyping; RP operation; Testing of materials;

D O I：

10.4028/www.scientific.net/AMM.308.25

中图分类号：

学科分类号：

摘要：

This paper deals with basic knowledge and problems in area of Rapid Prototyping (RP) technology operation focused on used material testing and operation optimization from economical aspects of view. It belongs to progressive methods of model creation based on geometry obtained from CAD environment with application possibilities in different industrial spheres. Chapters are focused on optimization of Rapid Prototyping preparation and operation process. There also is algorithm that leads to selection of suitable RP operation settings. Utilization of algorithm is presented on case of part production with use of UPrint device and Catalyst software, system created for utilization of Fused Deposition Modelling (FDM) technology. © (2013) Trans Tech Publications, Switzerland.

引用

页码：25 / 31

页数：6

共 8 条

[1]

Plancak M., Rapid Prototyping & Rapid Tooling. FTN Publishing, Novi Sad, (2009)

[2]

Pilipovic A., Raos P., Sercer M., Experimental testing of quality of polymer parts produced by Laminated Object Manufacturing - LOM, Technical Gazette, 18, 2, pp. 253-260, (2011)

[3]

Pop D., Berce P., Grozav S., Muresan S., Filip A., Fodorean I., SLM Parameters and Their Influence In Additive Manufacturing. Automation In Production Planning, 13, pp. 179-183, (2012)

[4]

Ahn S.-H., Montero M., Odell D., Roundy S., Wright P.K., Anisotropic material properties of fused deposition modeling ABS, Rapid Prototyping, 8, 4, pp. 248-257, (2002)

[5]

Fecova V., Barna J., Janak M., Technology Rapid Prototyping and their Methods, Progressive Technologies of Machining, FMT TU, pp. 82-87, (2010)

[6]

Marcincinova L.N., Barna J., Fecova V., Janak M., Marcincin J.N., Intelligent design of experimental gearbox with rapid prototyping technology support. INES 2011, 15th, IEEE International Conference On Intelligent Engineering Systems, pp. 77-80, (2011)

[7]

Marcincinova L.N., Fecova V., Marcincin J.N., Janak M., Barna J., Effective utilization of Rapid Prototyping technology, Materials Science Forum, 713, pp. 61-66, (2012)

[8]

Marcincin J.N., Barna J., Marcincinova L.N., Fecova V., Analyses and Solutions on Technical and Economical Aspects of Rapid Prototyping Technology, Technical Gazette, 18, 4, pp. 657-661, (2011)

← 1 →