Effect of Gasoline/Diesel and n-Butanol/Diesel Blends on Combustion and Emissions of PPCI

被引：0

作者：

Li L. ^{[1
]}

Mao B. ^{[1
]}

Zheng Z. ^{[1
]}

Yao M. ^{[1
]}

机构：

[1] State Key Laboratory of Engines, Tianjin University, Tianjin

来源：

Neiranji Xuebao/Transactions of CSICE (Chinese Society for Internal Combustion Engines) | 2020年 / 38卷 / 04期

关键词：

Blending fuels; Blending ratio; Heavy-duty diesel engine; Partially premixed compression ignition(PPCI);

D O I：

10.16236/j.cnki.nrjxb.202004038

中图分类号：

学科分类号：

摘要：

Gasoline/diesel and n-butanol/diesel blending fuels were applied to a high-pressure common-rail heavyduty diesel engine by the ratio of 40%, 60% and 80% in volume fraction.The effect of gasoline and n-butanol blending diesel fuel on the combustion and emission characteristics of partially premixed combustion ignition (PPCI)mode was studied in the operating condition of 0.48 MPa and 0.95 MPa BMEP.The test results show that with the increase of gasoline and n-butanol blending ratio, the ignition delay extends significantly, which helps to separate the combustion process from injection events.Under 0.48 MPa BMEP operating condition, all blending fuels is easy to achieve a high ratio of premixed combustion.40% blending fuels with EGR is able to comply EURO Ⅵ emission legislation, however, 80% blending fuels encounter high pressure rise rate and low combustion efficiency issue.When the engine comes to 0.95 BMEP operating condition, the ignition delay and premixed combustion ratio of each blending fuel decrease evidently.Both 40% and 60% blending fuels combustion appears as diffusion combustion.Compared to gasoline, n-butanol obtain lower brake specific fuel consumption(BSFC) and soot emission at a lower blending ratio.80% n-butanol blending fuels with a medium ratio of EGR achieves 87% premixed combustion with 0.4 g/(kW•h) NOx emission and 0.001 5 g/(kW•h) soot emission. © 2020, Editorial Office of the Transaction of CSICE. All right reserved.

引用

页码：289 / 297

页数：8

共 18 条

[11] Hohenberg G F., Advanced approaches for heat transfer calculations, (1979)
[12] Leermakers C, Bakker P, Somers L, Et al., Butanoldiesel blends for partially premixed combustion, SAE Internationla Journal of Fuels and Lubricants, 6, 1, pp. 217-229, (2013)
[13] Solaka H, Aronsson U, Tuner M, Et al., Investigation of partially premixed combustion characteristics in low load range with regards to fuel octane number in a lightduty diesel engine, (2012)
[14] 2
[15] Yao M, Zhang Q, Liu H, Et al., Diesel engine combustion control: Medium or heavy EGR, (2010)
[16] Cheng A S, Dibble R W, Buchholz B A., The effect of oxygenates on diesel engine particulate matter, (2002)
[17] Choi C Y, Reitz R D., An experimental study on the effects of oxygenated fuel blends and multiple injection strategies on DI diesel engine emissions, Fuel, 78, pp. 1303-1317, (1999)
[18] 3

← 1 2 →