Design and Test of Foreign Fiber Removal Machine Based on Embedded System

被引：0

作者：

Zhang C. ^{[1
]}

Sun S. ^{[2
]}

Shi W. ^{[3
]}

Zeng L. ^{[1
]}

Deng D. ^{[1
]}

机构：

[1] School of Electronic Information, Wuhan University, Wuhan

[2] International School of Software, Wuhan University, Wuhan

[3] School of Remote Sensing and Information Engineering, Wuhan University, Wuhan

来源：

Nongye Jixie Xuebao/Transactions of the Chinese Society for Agricultural Machinery | 2017年 / 48卷 / 08期

关键词：

Embedded system; Foreign fiber of cotton; Foreign fiber removal machine; Machine vision; Sub-pixel spatial separation correction;

D O I：

10.6041/j.issn.1000-1298.2017.08.004

中图分类号：

学科分类号：

摘要：

The embedded system based on FPGA+DSP was suitable for the agricultural sorting field, due to its flexible chip selection and high power efficiency. The embedded system was designed based on the principle of detection, software and hardware design and rejection system design. In principle of detection, a polarization channel was added to the UV channel to resolve the problem of transparent film detection without increasing camera. In software design, a speed measurement based on spatial correction and a learning algorithm for threshold detection was proposed to improve the adaptation of the equipment. An embedded solution was put forward which had advantages in both material cost and power consumption. After optimization, the DSP embedded board could stably process camera image data in real time. In rejection system, a control scheme was designed based on target real-time speed. The experiment result showed that the speed measurement scheme was verified via roller platform, and cotton speed can be obtained in the production line test. The embedded system could meet the real-time requirement, and the system was stable under varying foreign fiber numbers in long-term test. Concerning the test of rejection system, an impact test was performed by changing the wind speed. Finally, two typical foreign fiber detection tests of the system were implemented. The results showed that the detection rates of foreign fibers and polypropylene filaments as well as transparent films were higher than 80%, while the detection rate of yellowish foreign fibers was slightly lower than 80%. In the comparison test with similar equipment, the present equipment revealed superior detection rate. Long-term test result showed that the present equipment was easy to operate and had stable performance. © 2017, Chinese Society of Agricultural Machinery. All right reserved.

引用

页码：43 / 52

页数：9

共 19 条

[1]

Yang W., Li D., Wei X., Et al., Selection of optimal band for detection foreign fibers in lint cotton using spectroscopic analysis, Transactions of the CSAE, 25, 10, pp. 186-192, (2009)

[2]

Wang X., Detection of pseudo-foreign fibers based on computer vision, (2015)

[3]

Yang W., Li D., Wei X., Et al., Toward image segmentation of foreign fibers in lint, Transactions of the Chinese Society for Agricultural Machinery, 40, 3, pp. 156-160, (2009)

[4]

Yang W., Li D., Wei X., Et al., AVI system for classification of foreign fibers in cotton, Transactions of the Chinese Society for Agricultural Machinery, 40, 12, pp. 177-181, (2009)

[5]

Zhao X., Li D., Yang W., Et al., Feature selection for cotton foreign fiber objects based on improved ant colony algorithm, Transactions of the Chinese Society for Agricultural Machinery, 42, 4, pp. 168-173, (2011)

[6]

Zhao X., Li D., Yu H., Online detection for cotton foreign fiber based on fisher score and binary particle swarm optimization, Transactions of the CSAE, 30, 6, pp. 107-115, (2014)

[7]

Wang X., Li D., Yang W., Et al., Lint cotton pseudo-foreign fiber detection based on visible spectrum computer vision, Transactions of the Chinese Society for Agricultural Machinery, 46, 8, pp. 7-14, (2015)

[8]

Zheng W., Wang J., Liu S., Et al., Reaserch on dynamic identification technology of cotton foreign fibers, Chinese Journal of Scientific Instrument, 30, 10, pp. 2203-2207, (2009)

[9]

Ramesh B., Bhardwaj A., Justin R., Optimization and evaluation of image- and signal-processing kernels on the TI C6678 multi-core DSP, IEEE High Performance Extreme Computing Conference (HPEC), pp. 1-6, (2014)

[10]

Pauwels K., Tomasi M., Javier D., Et al., A comparison of FPGA and GPU for real-time phase-based optical flow, stereo, and local image features, IEEE Transactions on Computers, 61, 7, pp. 999-1012, (2012)

← 1 2 →