A fault-phase selection method based on natural frequency of traveling wave and atomic energy entropy

被引：0
作者：
机构：
[1] School of Electrical Engineering, Wuhan University, Wuhan 430072, Hubei Province
来源：
Xu, G. (xugao.121310@163.com) | 1688年 / Power System Technology Press卷 / 38期
关键词：
Atom-decomposition; Energy entropy; Fault phase selection; Natural frequencies; Transient components;
D O I：
10.13335/j.1000-3673.pst.2014.06.042
中图分类号：
学科分类号：
摘要：
Accurately recognizing the characteristics of natural frequency component contained in fault signal is the core of the fault-phase selection algorithm based on the component. The relation between the fault type and the natural frequency energy contained in phase current during the fault is analyzed, and a fault-phase selection method by directly analyzing the natural frequency characteristics in phase current is proposed based on the following phenomenon: during multi-phase short-circuit fault, when power frequency component in fault current is filtered, in all faulty phases there are obvious natural frequency components and these natural frequencies are the same while the natural frequency energy in the healthy phase is very weak; under single-phase grounding fault there is not stable natural frequency components in all phases. The atom-decomposition algorithm is applied in fault current analysis, if there is obvious natural frequency component, this component corresponds to the dominant atom and its energy entropy is the maximum, thus according to the energy entropy value of dominant atom in phase current and the natural frequency, the fault-phase can be selected. Simulation results show that the proposed method possesses satisfied ability to recognize natural frequency and the results of fault-phase selection are stable and reliable.
引用
收藏
页码：1688 / 1693
页数：5
相关论文
共 22 条
  • [11] Swift G.W., The spectra of fault-induced transients, IEEE Transactions on Power Apparatus and Systems, 98, 3, pp. 940-947, (1979)
  • [12] Lin S., He Z., Li X., Et al., Single terminal fault location by natural frequencies of travelling wave considering its time-domain characteristics, Power System Technology, 36, 7, pp. 243-248, (2012)
  • [13] Wu L., He Z., Qian Q., A single ended fault location method using traveling wave natural frequency, Proceedings of the CSEE, 28, 10, pp. 69-75
  • [14] Li X., He Z., Wu X., Et al., Natural frequencies based fault location method for transmission network considering measurement device invalidation, Power System Technology, 37, 5, pp. 1217-1222, (2013)
  • [15] Wang X., Huang S., New method of phase selection of EHV lines based on natural frequency, High Voltage Engineering, 35, 6, pp. 1502-1508, (2009)
  • [16] Chen S., He Z., Li X., Faulty phase selection for UHV transmission lines based on natural frequencies of traveling waves, Power System Technology, 35, 6, pp. 15-21, (2011)
  • [17] Wu L., He Z., Qian Q., A frequency domain approach to single-ended traveling wave fault location, Proceedings of the CSEE, 28, 25, pp. 99-104
  • [18] Lin S., Wu X., He Z., Et al., A power system fault location method based on natural frequencies of traveling waves, Power System Technology, 31, 7, pp. 270-275, (2013)
  • [19] Li X., Gong Q., Jia J., Et al., Atomic sparse decomposition based identification method for low-frequency oscillation modal parameters, Transactions of China Electrotechnical Society, 27, 9, pp. 124-133, (2012)
  • [20] Li X., Gong Q., Jia J., A detection method for low frequency oscillation dominant modes based on atomic decomposition energy entropy, Proceedings of the CSEE, 32, 1, pp. 131-139, (2012)
123