Dynamic simulation and cutting conditions optimization of tee slot milling based on cutpro software

被引：1
作者：
Li, Zhongqun [1 ]
机构：
[1] School of Metallurgy, Hunan University of Technology, Zhuzhou, Hunan
来源：
Key Engineering Materials | 2009年 / 407-408卷
关键词：
Cutting conditions optimization; Dynamic simulation; Stability lobes; Tee slot milling;
D O I：
10.4028/www.scientific.net/KEM.407-408.589
中图分类号：
学科分类号：
摘要：
Based on the dynamic simulation module of CutPro, the dynamic cutting forces and chatter limits for tee slot milling were predicated by setting the geometry of a tee slotting cutter. The chatter stability lobes under a given axial depth of cut are obtained by further programming, which is essential for chatter-free tee slot milling. A methodology of cutting conditions optimization for tee slot milling is presented, in which the minimal cutting time is used as the target function and the stability limits are introduced into the constraint conditions to reflect the vibration characteristics of milling operation. This optimization method has been validated by experimental tests. © (2009) Trans Tech Publications, Switzerland.
引用
收藏
页码：589 / 593
页数：4
相关论文
共 10 条
  • [1] Fu H.J., Devor R.E., Journal of Engineering for Industry, 106, pp. 81-88, (1984)
  • [2] Depince P., Hascoet J.Y., International Journal of Machine Tools & Manufacture, 46, 9, pp. 937-944, (2006)
  • [3] Yucesan G., Altintas Y., Journal of Engineering for Industry, 118, pp. 95-103, (1996)
  • [4] Kim H.S., Ehmann K.F., International Journal of Machine Tools & Manufacture, 22, 5, pp. 651-673, (1993)
  • [5] Endres W.J., DeVor R.E., Kapoor S.G., Transactions of the ASME, Journal of Engineering for Industry, 117, 4, pp. 526-541, (1995)
  • [6] Engin S., Altintas Y., International Journal of Machine Tools & Manufacture, 41, 15, pp. 2213-2231, (2001)
  • [7] Salami R., Sadeghi M.H., International Journal of Machine Tools & Manufacture, 47, pp. 760-767, (2007)
  • [8] Tandon V., El-Mounayri H., International Journal of Machine Tools & Manufacture, 42, pp. 595-605, (2002)
  • [9] An L.B., Chen M.Y., The Fourth International Conference on Control and Automation (ICCA'03), 1, pp. 839-841, (2003)
  • [10] LI Z.Q., Dynamic Modeling Simulation and Optimization of High Speed Milling under Complicated Cutting Conditions, pp. 1-159, (2008)
1