Analytical and experimental study on the effect of T-stress on behavior of closed cracks

被引：0
作者：
Zhao Y. [1 ,2 ]
Fan Y. [1 ,2 ]
Zhu Z. [1 ,2 ]
Zhou C. [1 ,2 ]
Qiu H. [1 ,2 ]
机构：
[1] Key Laboratory of Deep Underground Science and Engineering, Ministry of Education, Sichuan University, Chengdu, 610065, Sichuan
[2] College of Architecture and Environment, Sichuan University, Chengdu, 610065, Sichuan
来源：
Yanshilixue Yu Gongcheng Xuebao/Chinese Journal of Rock Mechanics and Engineering | 2018年 / 37卷 / 06期
基金：
中国国家自然科学基金;
关键词：
Closed crack; Crack initiation angles; Rock mechanics; Stress intensity factor; T-stress;
D O I：
10.13722/j.cnki.jrme.2017.1563
中图分类号：
学科分类号：
摘要：
The effects of T-stress on the behavior of closed cracks under compression were investigated. According to the stress conditions on crack surfaces,the analytical solution of stresses near the crack tip was obtained through the Muskhelishvili method of complex functions. The rectangle specimens of sandstone with an inclined crack were tested under uniaxial compression. The calculated results were compared with the test results of sandstone specimens and the previous test results of PMMA specimens to validate the theoretical solutions. The analytical solution of stresses at the closed crack tips has two parts:the singularity terms which are the same as the traditional stresses expressed in terms of stress intensity factors K,and non-singularity terms expressed in terms of three components of T-stress,i.e. Tx,Ty and Txy. The theoretical results considering the three components Tx,Ty and Txy fit the test results of both PMMA and sandstone specimens better. The theoretical analysis shows that the tangential stress increases and initiation angles decreases when T-stresses are not considered. When T-stresses are considered,the predicted values which contain three T-stress components(Tx,Ty and Txy) are situated between the results which only consider Tx and the results which consider both Tx and Ty. Thus,the T-stress near crack tips should have three components Tx,Ty and Txy,and all of them affect the crack behavior obviously. © 2018, Science Press. All right reserved.
引用
收藏
页码：1340 / 1349
页数：9
相关论文
共 41 条
  • [31] Awaji H., Sato S., Combined mode fracture toughness measurement by the disk test, Journal of Engineering Materials and Technology Transactions of the ASME, 100, 2, pp. 175-182, (1978)
  • [32] Fan T., Fundamental of fracture theory, pp. 56-57, (2003)
  • [33] Zhang Q., Hou A., Yun X., Et al., Research progress on rock biaxial compression test and device, Journal of Henan Polytechnic University, 26, 4, pp. 440-445, (2007)
  • [34] Guo S., The experimental and theoretical investigation on fracture of rock-type materials under compressive loading[Ph. D. Thesis], (2003)
  • [35] Zhou S., Guo S., Li X., T-stress’s impact on rock’s fracture toughness and propagation path, Journal of Central South University, 40, 3, pp. 797-802, (2009)
  • [36] Ayatollahi M.R., Aliha M.R.M., On the use of Brazilian disc specimen for calculating mixed mode I-II fracture toughness of rock materials, Engineering Fracture Mechanics, 75, 16, pp. 4631-4641, (2008)
  • [37] Schmidt R.A., A micro-crack model and its significance to hydraulic fracturing and fracture toughness testing, Proceedings of the 21st US Symposium on Rock Mechanics. [S. l. ]: [s. n. ], pp. 58-90, (1980)
  • [38] Khan K., Al-Shayea N.A., Effect of specimen geometry and testing method on mixed I-II fracture toughness of a limestone rock from Saudi Arabia, Rock Mechanics and Rock Engineering, 33, 3, pp. 179-206, (2000)
  • [39] Chang S.H., Lee C.I., Jeon S., Measurement of rock fracture toughness under modes I and II and mixed-mode conditions by using disc- type specimen, Engineering Geology, 66, 1-2, pp. 79-97, (2002)
  • [40] Chaker C., Barquins M., Sliding effect on branch crack, Physics and Chemistry of the Earth, 21, 4, pp. 319-323, (1996)
12345