Review on the recycling technologies of electronic components from waste printed circuit boards

被引：0

作者：

Sun C. ^{[1
]}

Guo J. ^{[1
]}

Wang J. ^{[1
]}

Xu Z. ^{[1
]}

机构：

[1] School of Environmental Science and Engineering, Shanghai Jiao Tong University, Shanghai

来源：

Cailiao Daobao/Materials Review | 2016年 / 30卷 / 05期

关键词：

Disassembling technology; Electronic components; Recycling technology; Unsoldering methods; WPCBs;

D O I：

10.11896/j.issn.1005-023X.2016.09.017

中图分类号：

学科分类号：

摘要：

Electronic components are widely used in the electronic and electrical appliances. However, large quantities of electronic components are coming into discarding period due to the endless requirement for new products and market explosion for electronic and electrical products. The valuable materials and toxic materials of electronic components are analyzed. The new recycling processes for electronic components are reviewed, including the disassembling technologies (unsoldering methods and separation methods) and recycling technologies. On this basis, some new trends and suggestions on recovery of electronic components in waste printed circuit boards (WPCBs) are put forward. © 2016, Materials Review Magazine. All right reserved.

引用

页码：105 / 109

页数：4

共 28 条

[11]

Pan X., Long D., Yang J., Et al., Experimental study of molten solder removal from discarded printed circuit board by blowing-off method, J Mechanical Eng, 46, 19, (2010)

[12]

Duan H., Hou K., Li J., Et al., Examining the technology acceptance for dismantling of waste printed circuit boards in light of recycling and environmental concerns, J Environ Management, 92, 3, (2011)

[13]

Zhou Y., Qiu K., A new technology for recyclingmaterials from waste printed circuit boards, J Hazard Mater, 175, 1-3, (2010)

[14]

Zebedin H., Daichendt K., Kopacek P., A new strategy for a flexible semi-automatic disassembling cell of printed circuit boards, Conference Record of the 2001 IEEE International Symposium on Industrial Electronics, (2001)

[15]

Knoth R., Brandstotter M., Kopacek B., Et al., Automated disassembly of electronic equipment, Conference Record of the 2002 IEEE International Symposium on Electronics and the Environment, (2002)

[16]

Song S., Liu W., Liu G., Et al., Study of heating methods for disassembling components on PCBs based on TOPSIS, J Hefei University of Technology, 32, 7, (2009)

[17]

Stobbe I., Griese H., Potter H., Et al., Quality assured disassembly of electronic components for reuse, Conference Record of the2002 IEEE International Symposium on Electronics&the Environment, (2002)

[18]

Yi R., Chen X., Study on the equipment fro automatic disassembly of electronic components in printed circuit boards scrap, Agricultural Equipment Vehicle Eng, 197, 9, (2007)

[19]

Gibson A., Park Y.P., Fray D.J., Recovery of components and valuable metals from printed circuit boards, Epd Congress Proceedings, (2009)

[20]

Liu J., Duan N., Yang H., Et al., A technology for di-sassembling electronic components from waste printed circuit boards using nitric acid as leaching liquor, Res Environ Sci, 23, 10, (2010)

← 1 2 3 →