Preparation and insulating properties of modified BN-Si-B/epoxy resin composites

被引：0

作者：

Chen H. ^{[1
]}

Huang Z. ^{[1
]}

Zhao W. ^{[1
]}

Song J. ^{[1
]}

Zhou Y. ^{[1
]}

Lin X. ^{[1
]}

Weng L. ^{[1
]}

机构：

[1] School of Materials Science and Chemical Engineering, Harbin University of Science and Technology, Harbin

来源：

Fuhe Cailiao Xuebao/Acta Materiae Compositae Sinica | 2024年 / 41卷 / 05期

关键词：

BN; composites; corona resistance life; dielectric properties; epoxy resin;

D O I：

10.13801/j.cnki.fhclxb.20230825.005

中图分类号：

学科分类号：

摘要：

Corona discharge can adversely affect the stable operation and service life of electrical equipment. Therefore, it is crucial to enhance the corona resistance of insulation materials to ensure the normal functioning of electrical equipment. In this study, modified BN (fBN) was synthesized by treating boron nitride (BN) with a silane coupling agent, and subsequently blended with dispersant (organosilicon boron composite oxide (Si-B)) to modify epoxy resin (EP). The fBN-Si-B/EP composites with different fBN contents were prepared by blending and thermosetting methods. The corona resistance life of epoxy resin was significantly enhanced. The experimental findings revealed that the corona resistance life of fBN-Si-B/EP composites at an electric field strength of 30 kV·mm-1 and temperature of 30℃ was up to 114.8 h, which was 5.01 times greater than that of pure epoxy resin. The dielectric constant of the fBN-Si-B/EP composite shows an increasing trend with the increase of the fBN doping. At the same time, the volume resistivity and breakdown strength of the composites show a trend of decreasing and then increasing. The addition of a small amount of fBN can reduce the relative dielectric constant of the composite and suppress the increase of dielectric loss. While the breakdown strength and volume resistivity of fBN-Si-B/EP composites are slightly reduced with the addition of fBN particles, with a minimum volume resistivity of 6.65×1014 Ω·cm and a minimum breakdown strength of 24.04 kV·mm-1, they still exhibit good insulation properties. © 2024 Beijing University of Aeronautics and Astronautics (BUAA). All rights reserved.

引用

页码：2477 / 2486

页数：9

共 32 条

[1]

YANG H D, CHEN Q G, WANG X Y, Et al., Dielectric and thermal conductivity of epoxy resin impregnated nano-h-BN modified insulating paper[J], Polymers, 11, 8, pp. 1359-1372, (2019)

[2]

YAO T, CHEN K, SHAO T, Et al., Nano-BN encapsulated micro-AlN as fillers for epoxy composites with high thermal conductivity and sufficient dielectric breakdown strength[J], IEEE Transactions on Dielectrics and Electrical Insulation, 27, 2, pp. 528-534, (2020)

[3]

LI S T, YIN G L, CHEN G, Et al., Short-term breakdown and long-term failure in nanodielectrics: A review[J], IEEE Transactions on Dielectrics and Electrical Insulation, 17, 5, pp. 1523-1535, (2010)

[4]

NAZIR M T, PHUNG B T, YU S H, Et al., Resistance against AC corona discharge of micro-ATH/nano-Al2O3 co-filled silicone rubber composites[J], IEEE Transactions on Dielectrics and Electrical Insulation, 25, 2, pp. 657-667, (2018)

[5]

ZHAO W, CHEN H, FAN Y, Et al., Effect of size and content of SiO2 nanoparticle on corona resistance of silicon-boron composite oxide/SiO2/epoxy composite[J], Journal of Inorganic and Organometallic Polymers and Materials, 30, 11, pp. 4753-4763, (2020)

[6]

ZHAO W, FAN Y, CHEN H., Dielectric properties and corona resistance of Si-B/epoxy nano-composites[J], Journal of Materials Science: Materials in Electronics, 30, 17, pp. 16298-16307, (2019)

[7]

LAO J P, XIE H A, SHI Z Q, Et al., Flexible regenerated cellulose/boron nitride nanosheet high-temperature dielectric nanocomposite films with high energy density and breakdown strength[J], ACS Sustainable Chemistry & Engineering, 6, 5, pp. 7151-7158, (2018)

[8]

WANG D Z, WEI H, LIN Y, Et al., Achieving ultrahigh thermal conductivity in Ag/MXene/epoxy nanocomposites via filler-filler interface engineering[J], Composites Science and Technology, 213, (2021)

[9]

LEE D J, LEE S Y, BYUN S, Et al., Novel dielectric BN/epoxy nanocomposites with enhanced heat dissipation performance for electronic packaging, Composites Part A: Applied Science and Manufacturing, 107, pp. 217-223, (2018)

[10]

KIM K, KIM M, HWANG Y, Et al., Chemically modified boron nitride-epoxy terminated dimethylsiloxane composite for improving the thermal conductivity[J], Ceramics International, 40, 1, pp. 2047-2056, (2014)

← 1 2 3 4 →