Comparison measurement of the distance between axes of holes with the roundtest RA-120 and Thome präzision-rapid

被引：3

作者：

Michalik, Peter ^{[1
]}

Zajac, Jozef ^{[1
]}

Hatala, Michal ^{[1
]}

Hutyrová, Zuzana ^{[1
]}

Mital, Dusan ^{[1
]}

Olhova, Jaroslava ^{[1
]}

机构：

[1] TU Kosice

来源：

Applied Mechanics and Materials | 2014年 / 616卷

关键词：

Alignment; Distance of holes; Roundtest RA-120; Thome präzicion-rapid;

D O I：

10.4028/www.scientific.net/AMM.616.284

中图分类号：

O3 [力学];

学科分类号：

08 ; 0801 ;

摘要：

In this article are compared two ways of measuring axial holes distance. The first method was implemented for measuring equipment Roudtest RA-120. The second method was implemented on the device Thome Präcision. © (2014) Trans Tech Publications, Switzerland.

引用

页码：284 / 291

页数：7

共 13 条

[1]

Bruning A.W.J., Patterson S., Bryan J., Knight P., Grazing Incidence Interferometry for High Precision Measurements of Cylindrical Form Deviations, Manuf, Technol, 50, 1, pp. 381-384, (2001)

[2]

Duplak J., Verification of T-vc According to ISO 3685, In: Progressive Machining Technology, pp. 45-52, (2010)

[3]

Eggenberger G., Ivanco V., Kostolny K., Murcinkova Z., Probabilistic Solution By Force Polygon Method In Orthogonal Machining, 4, 1, pp. 53-55, (2005)

[4]

Fabian M., Et al., Influence of the CAM parameters and selection of end-mill cutter when assessing the resultant surface quality in 3D milling, Applied Mechanics and Materials, 474, pp. 267-272, (2014)

[5]

Fedorko G., Molnar V., Magac K., Basics ProEngineer applications in technical design, 1st Ed, Kosice, 2006

[6]

Kramer T.R., Automatic generation of NC-code for hole cutting with in-process metrology, Proc. of 6th IEEE Conf. Rec. Instrum. Meas. Technol, (1989)

[7]

Krenicky T., Measuring system for contactless characterization of surface geometry, Strojárstvo, 13, 1-13, (2012)

[8]

Michalik P., Zajac J., Fecova V., Duplak J., Olhova J., Measurment of the distance between axes of holes with the Roundtest RA-120, Proc. of 12 Th IEEE Conf., Herľany, (2014)

[9]

Simkulet V., Fecova V., Vojtko I., Study of microstructural characteristics EN S233J2G3 steel after plasma cutting and laser, Transfer 2012, Trencin, pp. 1-4, (2012)

[10]

Peterka J., Morovic L., Pokorny P., Kovac M., Hornak F., Optical 3D Scanning of Cutting Tools, Appl. Mech. Mater, 421, pp. 663-667, (2013)

← 1 2 →