Shrinkage computation of injection molded parts

被引：0
|
作者：
Zhu, Tieli [1 ]
Wang, Minjie [1 ]
机构：
[1] Dalian Univ. of Technol., Dalian 116023, China
来源：
Jixie Gongcheng Xuebao/Chinese Journal of Mechanical Engineering | 2002年 / 38卷 / 09期
关键词：
D O I：
10.3901/jme.2002.09.145
中图分类号：
学科分类号：
摘要：
Injection molding
引用
收藏
页码：145 / 149
相关论文
共 50 条
  • [21] ON SHRINKAGE OF INJECTION MOLDED PRODUCTS
    SATOH, H
    JOURNAL OF RHEOLOGY, 1980, 24 (03) : 339 - 340
  • [22] An Analytical Study of Constrained Shrinkage of Injection Molded Semi-Crystalline Plastic Parts
    Azdast, T.
    Behravesh, A. H.
    POLYMER-PLASTICS TECHNOLOGY AND ENGINEERING, 2008, 47 (12) : 1265 - 1272
  • [23] EFFECTS OF PROCESS PARAMETERS ON SHRINKAGE UNIFORMITY AND BIREFRINGENCE OF INJECTION-COMPRESSION MOLDED PARTS
    Huang, Han-Xiong
    Yang, Can
    Li, Kun
    IMECE 2008: PROCESSING AND ENGINEERING APPLICATIONS OF NOVEL MATERIALS, VOL 15, 2008, : 193 - 200
  • [24] As-molded shrinkage measurements on polystyrene injection molded products
    Jansen, KMB
    Pantani, R
    Titomanlio, G
    POLYMER ENGINEERING AND SCIENCE, 1998, 38 (02): : 254 - 264
  • [25] Analysis of the shrinkage of injection-molded fiber-reinforced thin-wall parts
    Masato, Davide
    Rathore, Jitendra
    Sorgato, Marco
    Carmignato, Simone
    Lucchetta, Giovanni
    MATERIALS & DESIGN, 2017, 132 : 496 - 504
  • [26] Numerical simulation and experimental validation of residual stress induced constrained shrinkage of injection molded parts
    Azdast, Taher
    Behravesh, Amir Hossein
    Mazaheri, Kiumars
    Darvishi, Mohammad Mehdi
    POLIMERY, 2008, 53 (04) : 304 - 310
  • [27] Numerical simulation and experimental validation of residual stress induced constrained shrinkage of injection molded parts
    Tarbiat Modares University, Department of Mechanical Engineering, P.O.Box 14115-143, Tehran, Iran
    不详
    Polim, 2008, 4 (304-310): : 304 - 310
  • [28] NEW DESIGN OF INJECTION MOLDED PARTS
    BEALL, G
    KUNSTSTOFFE-GERMAN PLASTICS, 1990, 80 (08): : 911 - 914
  • [29] Thermoelasticity of Injection-Molded Parts
    Turk, Janez
    Svensek, Daniel
    POLYMERS, 2023, 15 (13)
  • [30] Morphology Distribution in Injection Molded Parts
    Liparoti, Sara
    Salomone, Rita
    Speranza, Vito
    Pantani, Roberto
    POLYMERS, 2024, 16 (03)
12345