Galling growth analysis in metal forming

被引：3

作者：

Kitano H. ^{[1
]}

Dohda K. ^{[2
]}

Kalin M. ^{[3
]}

Ehmann K.F. ^{[2
]}

机构：

[1] Research Center for Structural Materials, National Institute for Materials Science

[2] Department of Mechanical Engineering, Northwestern University

[3] Faculty of Mechanical Engineering, University of Ljubljana

来源：

Manufacturing Letters | 2018年 / 16卷

关键词：

Adhesion; Dry metal forming; Finite element analysis; Galling growth modeling;

D O I：

10.1016/j.mfglet.2018.03.003

中图分类号：

学科分类号：

摘要：

In this study, the applicability of adhesion calculations by an adhesion growth model, proposed by the authors, is investigated. The adhesion calculation results obtained by the adhesion growth model are compared with experimental results obtained under different sliding distance and contact surface temperature conditions. It is shown that the adhesion growth model can simulate the initiation and early stage behavior of galling. © 2018 Society of Manufacturing Engineers (SME)

引用

页码：32 / 35

页数：3

共 50 条

[41] EFFECT OF GALLING ON METAL FRACTURE IN CUP IRONING PROCESS
SAITO, M
SAIKI, H
KAWAI, N
JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME, 1989, 111 (04): : 692 - 697
[42] Process design and sensitivity analysis in metal forming
Doltsinis, I
Rodic, T
INTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN ENGINEERING, 1999, 45 (06) : 661 - 692
[43] Damage analysis of sheet metal forming for IF steel
Jing Huang
Li-jun Li
Cheng-wu Shen
Journal of Central South University of Technology, 2007, 14 : 365 - 368
[44] CONCERNING ANALYSIS OF CENTRAL BURST IN METAL FORMING
LEE, EH
MCMEEKING, RM
JOURNAL OF ENGINEERING FOR INDUSTRY-TRANSACTIONS OF THE ASME, 1978, 100 (03): : 386 - 387
[45] ANALYSIS OF UNCONVENTIONAL TEE FORMING ON METAL TUBES
FILHO, LAM
MENEZES, JC
ALQURESHI, HA
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 1994, 45 (1-4) : 383 - 388
[46] Damage analysis of sheet metal forming for IF steel
Huang, Jing
Li, Li-jun
Shen, Cheng-wu
JOURNAL OF CENTRAL SOUTH UNIVERSITY OF TECHNOLOGY, 2007, 14 (Suppl 1): : 365 - 368
[47] Numerical analysis of void closure in metal forming
Park, Jong-Jin
PROCEEDINGS OF THE 17TH INTERNATIONAL CONFERENCE ON METAL FORMING METAL FORMING 2018, 2018, 15 : 1841 - 1846
[48] An analysis of ironing limit in sheet metal forming
Nam, J
Han, KS
FRACTURE AND STRENGTH OF SOLIDS, PTS 1 AND 2, 2000, 183-1 : 547 - 552
[49] Ductile damage analysis of sheet metal forming
Elgueta, M
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 2002, 121 (01) : 148 - 156
[50] Analysis of ironing limit in sheet metal forming
Nam, Jaebok
Han, Kyung Seop
Key Engineering Materials, 2000, 183

← 1 2 3 4 5 →