Principle Design and Characteristic Analysis of Ultrasonic Motor for Direct Drive Servo Valve

被引：0

作者：

Liu, Guangjun ^{[1
]}

Liu, Kezhen ^{[1
]}

Lu, Liang ^{[1
,2
]}

Xu, Yinpeng ^{[1
]}

机构：

[1] School of Mechanical Engineering, Tongji University, Shanghai

[2] State Key Laboratory of Fluid Power and Mechatronic Systems, Hangzhou

来源：

Tongji Daxue Xuebao/Journal of Tongji University | 2024年 / 52卷 / 10期

关键词：

direct-drive servo valve; dynamic response; experimental test; modeling design; ultrasonic motor;

D O I：

10.11908/j.issn.0253-374x.22502

中图分类号：

学科分类号：

摘要：

To meet the design requirements of a rotary direct-drive servo valve for a small length-to-diameter ratio compact structure of the drive motor，an annular traveling wave type ultrasonic motor was designed starting from the demand of 200 Hz dynamic response of the servo valve power level. The basic working principle of the ultrasonic motor is analyzed and the stator-rotor friction transmission model of the ultrasonic motor is established. An ultrasonic motor characteristic test bench was built and the torque-speed test was conducted，based on which，the analysis of the influence characteristics of ultrasonic motor drive frequency and drive voltage was performed. The results show that the ultrasonic motor has the maximum working efficiency at a drive frequency of 49.8 kHz， the servo valve speed and torque working demand can be satisfied when the drive voltage is greater than 110 V，and the maximum working efficiency can be approached under a drive frequency of 49.8 Hz and 110 V drive voltage condition. © 2024 Science Press. All rights reserved.

引用

页码：1631 / 1639

页数：8

共 23 条

[11]

JEAN-JACQUES C, AMIT K., Electric actuation for flight and engine control：evolution and current trend［C］, 45th AIAA Aerospace Sciences Meeting and Exhibit, pp. 1391-1396, (2007)

[12]

NAKAOKA M., Ultrasonic motor-actuated valve direct driving and positioning motion control system using improved fuzzy reasoning controller, Industry Applications Society Meeting, pp. 368-375, (1994)

[13]

LI Q., Modeling and simulation of ultrasonic motor driving jet-pipe servo valve system, International Conference on System Simulation & Scientific Computing, pp. 688-692, (2008)

[14]

Liang LU, XIA Ffeiyan, YIN Yaobao, Et al., Dynamic analysis and optimization of ball-type rotary direct drive pressure servo valve［J］, Acta Aeronautica et Astronautica Sinica, 39, 10, (2018)

[15]

YUAN Jiayang, YIN Yaobao, LU Liang, Et al., Stability analysis of rotary direct-drive electro-hydraulic pressure servo valve［J］, Journal of Tongji University （Natural Science）, 46, 2, (2018)

[16]

YIN Yucong, YAO Zhiyuan, ZHAO Chunsheng, Experimental study on two combinations of traveling-wave rotary ultrasonic motor［J］, China Mechanical Engineering, 22, 1, (2011)

[17]

HUANG Yao, Research on the pneumatic control valve driven by ultrasonic motor ［D］, (2010)

[18]

Optimal and intelligent motion control scheme for an ultrasonic-motor-driven x-y stage ［J］, Mechatronics, 59, 4, (2019)

[19]

Wen JIN, WANG Qing, ZHOU Yang, Et al., The development and application of the new aerospace motor［J］, Navigation and Control, 15, 5, (2016)

[20]

PIAH K A M., Increasing the efficiency of traveling wave ultrasonic motor by modifying the stator geometry［J］, Ultrasonics, 64, 9, (2016)

← 1 2 3 →