Fabrication of Ti3CN quasi-MXene based poly glycidyl methacrylate and poly (3,4-ethylene dioxythiophene): Poly (styrene sulfonate) conducting polymer coated materials for photocatalytic eradicator of organic pollutants

MXene, a two-dimensional (2D) transition metal carbide or nitride, has gained significant attention due to its exceptional properties and wide-ranging applications. MXenes exhibit distinctive physical and chemical characteristics, making them suitable for electrocatalysis, supercapacitors, semiconductors, batteries, sensors, biomedicine, water splitting, and photocatalysis. In environmental photocatalysis, efforts have been made to improve conductivity, structural stability, and morphology. This study synthesized a photocatalyst by coating or doping a conducting polymer onto a quasi-MXene (Ti3CN) substrate. Initially, Ti3AlCN was exfoliated using HF to form 2D Ti3CN quasi-MXene, which was then doped with GMA and PEDOT: PSS conducting polymers for photocatalytic dye degradation. The broad heterogeneous interfaces in this network significantly enhance photocatalytic performance and pollutant removal capacity. The Ti3CN@GMA/PEDOT: PSS photocatalyst was characterized through SEM, FTIR, XPS, XRD, BET, and EDX techniques and tested for the degradation of various pollutants in wastewater under visible light. The degradation rates achieved were 94.1 % for Rose Bengal, 91.6 % for Rhodamine B, and 90.6% for Methylene Blue, with corresponding rate constants of 0.0366 min- 1 , 0.0400 min- 1 , and 0.0388 min- 1 over 60 min. The photocatalyst demonstrated excellent performance, highlighting several advantages, including low energy consumption, cost-effectiveness, non-toxic properties, and environmental compatibility, making it a promising solution for wastewater treatment applications.