Effect of pressure and welding parameters on weld bead geometry of GMAW in underwater hyperbaric dry environment

被引：0

作者：

Liu, Jian ^{[1
]}

Xue, Long ^{[1
]}

Huang, Jiqiang ^{[1
]}

Huang, Junfen ^{[1
]}

机构：

[1] Beijing Key Laboratory of Opto-Mechatronic Equipment Technology, Beijing Institute of Petro-Chemical Technology, Beijing,102617, China

来源：

Hanjie Xuebao/Transactions of the China Welding Institution | 2016年 / 37卷 / 02期

关键词：

Geometry - Reinforcement - Gas welding - Welding electrodes - Welds;

D O I：

暂无

中图分类号：

学科分类号：

摘要：

Underwater hyperbaric welding was conducted, with the ambient pressure, welding current, composition of welding gas and electrode extension as variables, to investigate the influence on the weld bead geometry. The variation trends of weld penetration, weld width and reinforcement with the above variables were determined by orthogonal experiments. The results show that with the increase of ambient pressure, the welding spatters, weld penetration and reinforcement increased, but the weld width decreased. In hyperbaric environment, with the increase of welding current, the weld width did not change significantly, but the weld penetration increased and the reinforcement also increased slightly. With the increase of CO2 ratio in shielding gas, the weld penetration decreased, the weld width increased, but the reinforcement had no obvious change. With the increase of electrode extension, the weld penetration decreased, the weld width and reinforcement increased. © 2016, Harbin Research Institute of Welding. All right reserved.

引用

页码：29 / 32