Terminal Sliding Mode Control for Dynamic Voltage Restorer

被引:0
作者
Inamdar J.J. [1 ]
Iyswarya Annapoorani K. [1 ]
机构
[1] Centre for Automation and School of Electrical Engineering, Vellore Institute of Technology, Chennai
关键词
dynamic voltage restorer; sliding mode control; voltage harmonics; Voltage quality;
D O I
10.13052/dgaej2156-3306.37318
中图分类号
学科分类号
摘要
Day by day the increment in non-linear load has deteriorated the Voltage Quality of power supply system. The crucial concerns originated are Voltage Sag and Voltage Harmonics. These power quality problems cause a lot of losses in the power system which results in commercial losses as well. The moderation of these issues within the permissible limits is much needed. Among, the several methods and devices that exist, the Dynamic Voltage Restorers (DVR) are often used. This paper focuses on mitigation of Voltage Sag and Voltage Harmonics. In the development phase of DVR, the design of controller is an important phase to be considered. The nonlinear control approach of design is superior to linear control. In this paper the Terminal Sliding Mode Control is used for designing the controller for DVR. To improve accuracy and robustness, an additional nonlinear quantity has been introduced to the equation of traditional Sliding Mode control. The Dynamic Voltage Restorer is modelled using MATLAB/Simulink and used for studies. The simulation results presented validates effectiveness of the proposed control approach. © 2021 River Publishers.
引用
收藏
页码:771 / 792
页数:21
相关论文
共 23 条
  • [1] IEEE recommended practices and requirements for harmonic control in electrical power systems, (1992)
  • [2] Bollen M. H. J., 'Understanding power quality problems Voltage Sags and interruptions, (2000)
  • [3] Slotin J. E., Li W., Applied Non-Linear Control, (1991)
  • [4] De Battistaand Hernan, Mantz Ricardo J., Harmonic Series Compensators in Power Systems: Their Control via Sliding Mode, IEEE Transactions on Control Systems Technology, 8, 6, (2000)
  • [5] Ruilin P., Yuegen Z., Sliding mode control strategy of dynamic Voltage restorer, IEEE International Conference on Industrial Electronics and Control Applications, pp. 1-3, (2005)
  • [6] Piatek K., Sliding mode control of DVR with minimized energy injection, IEEE European Conference on Power Electronics and Applications, (2005)
  • [7] Kolhatkar Y. Y., Errabelli R. R., Das S. P., A sliding mode controller based optimum UPQC with minimum VA loading, IEEE Power Engineering Society General Meeting, 1, pp. 871-875, (2005)
  • [8] Errabelli R. R., Kolhatkar Y. Y., Das S. P., Experimental investigation of DVR with slidingmode control, IEEE Power India Conference, (2006)
  • [9] Nagesh Kumar G. V., Chowdary D. D., DVR with sliding mode control to alleviate Voltage Sags on a distribution system for three phase short circuit fault, 2008 IEEE Region 10 and the Third international Conference on Industrial and Information Systems, pp. 1-4, (2008)
  • [10] Pires V. F., Marques G. D., Sousa D., Phase-locked loop topology based on a synchronous reference frame and sliding mode approach for DVR applications, IEEE International Conference on Computer as a Tool (EUROCON), pp. 1-4, (2011)