Development of Bunch-by-bunch Beam Position Measurement Electronics for High Energy Photon Source

被引：0

作者：

Zhang X. ^{[1
,2
]}

Zhang Q. ^{[1
,2
]}

Cao J. ^{[1
,2
]}

Ye Q. ^{[1
]}

Ma H. ^{[1
]}

Ma Y. ^{[1
,2
]}

Du Y. ^{[1
]}

Huang X. ^{[1
]}

Wei S. ^{[1
]}

Yue J. ^{[1
]}

Sui Y. ^{[1
,2
]}

机构：

[1] Institute of High Energy Physics, Chinese Academy of Sciences, Beijing

[2] University of Chinese Academy of Sciences, Beijing

来源：

Yuanzineng Kexue Jishu/Atomic Energy Science and Technology | 2020年 / 54卷 / 09期

关键词：

Bunch-by-bunch; High Energy Photon Source; High-speed signal acquisition; ZYNQ chip;

D O I：

10.7538/yzk.2019.youxian.0708

中图分类号：

学科分类号：

摘要：

A bunch-by-bunch beam position measurement (BPM) electronics for High Energy Photon Source (HEPS) storage ring was designed. The hardware of electronics consists of analog signal acquisition board and digital signal processing board. The software consists of underlying firmware and application software. The sampling frequency is 500 MHz, and the bandwidth is 1 GHz. The electronics digitizes four analog signals from BPM probe of storage ring, and obtains the amplitude of beam signal. ZYNQ chip was used to process the beam data and calculate the position of each bunch. Electronics test results in the laboratory is that the nonlinearity of ADC channels is less than 1% when the peak-to-peak value of input signal is less than 1.8 V, and spurious-free dynamic range is about 60 dB. When the sensitivity coefficient is 8.26 mm, the beam position resolution is less than 10 μm. The test results meet the needs of HEPS. © 2020, Editorial Board of Atomic Energy Science and Technology. All right reserved.

引用

页码：1709 / 1714

页数：5

共 15 条

[1]

(2015)

[2]

ZHOU Yimei, CHEN Zhichu, GAO Bo, Et al., Bunch-by-bunch phase study of the transient state during injection, Nuclear Instruments and Methods in Physics Research A, 955, (2020)

[3]

ZHOU Yimei, CHEN Hanjiao, CAO Shanshan, Et al., Bunch-by-bunch longitudinal phase monitor at SSRF, Nuclear Science and Techniques, 29, 8, pp. 3-8, (2018)

[4]

CHEN Hanjiao, CHEN Jie, GAO Bo, Et al., Bunch-by-bunch beam size measurement during injection at Shanghai Synchrotron Radiation Facility, Nuclear Science and Techniques, 29, 6, pp. 3-11, (2018)

[5]

DUAN Liwu, LENG Yongbin, YUAN Renxian, Et al., Injection transient study using a two-frequency bunch length measurement system at the SSRF, Nuclear Science and Techniques, 28, 7, pp. 38-43, (2017)

[6]

YANG Yong, LENG Yongbin, YAN Yingbing, Et al., Development of the bunch-by-bunch beam position acquisition system based on BEE cube, Nuclear Science and Techniques, 27, 2, pp. 88-93, (2016)

[7]

DENG Qingyong, CAO Jianshe, ZHANG Yuan, Et al., Development and application of bunch-by-bunch measurement system for BEPCⅡ storage ring, High Power Laser and Particle Beams, 27, 6, (2015)

[8]

DENG Qingyong, CAO Jianshe, YUE Junhui, Et al., Bunch-by-bunch beam loss monitor system in BEPCⅡstorage ring, High Power Laser and Particle Beams, 26, 10, pp. 279-282, (2014)

[9]

WANG Junhua, LIU Jianhong, ZHENG Kai, Et al., Design of bunch by bunch measuring and transverse feedback system at HLS, High Power Laser and Particle Beams, 18, 2, pp. 291-296, (2006)

[10]

REHM G, ABBOTT M G, MORGAN A F D, Et al., Measurement of longitudinal coupled bunch instabilities and status of new feedback system, IBIC2016, (2016)

← 1 2 →