Research on task-oriented warship formation support model and spare parts configuration method

被引：0

作者：

Xie J. ^{[1
]}

Zhang L. ^{[2
]}

机构：

[1] School of Mathematics, Dongbei University of Finance and Economics, Dalian

[2] Unit 92337 of PLA, Dalian

来源：

Xitong Gongcheng Lilun yu Shijian/System Engineering Theory and Practice | 2020年 / 40卷 / 12期

基金：

中国国家自然科学基金; 中国博士后科学基金;

关键词：

Accompanying support; Autonomous support; Formation; Monte Carlo; Optimization; Spare parts;

D O I：

10.12011/SETP2019-1709

中图分类号：

学科分类号：

摘要：

Spare parts were important support materials for planned repairs, temporary repairs and emergency repairs on the battlefield, which played an important role in the timely formation and long-term maintenance of equipment support capabilities. Aiming at the two typical support modes of autonomous support and accompanying support of ship formation during the maritime mission, an optimized model of spare parts configuration was established with the formation carrying capacity (total volume) as the constraint and the equipment availability as the objective function. Under the constraints of the same equipment availability index, the optimization schemes of spare parts configuration under different maintenance capabilities of the two support modes were compared and analyzed. The calculation results were verified by the Monte Carlo simulation model. The results of the case showed that the formation spare parts resources under the support mode had a higher utilization rate compared with autonomous support. The error between the simulation result and the analysis result was less than 4%, which further verified the correctness and feasibility of the model. Decision support was provided for formulating a reasonable support model and optimizing the plan for carrying spare parts during the maritime formation mission. © 2020, Editorial Board of Journal of Systems Engineering Society of China. All right reserved.

引用

页码：3298 / 3306

页数：8

共 17 条

[1] Sherbrooke C C., Optimal inventory modeling of systems: Multi-echelon techniques, (2004)
[2] Axsater S., A new decision rule for lateral transshipments in inventory systems, Management Science, 49, 9, pp. 1168-1179, (2003)
[3] Xu L, Li Q M, Li H, Et al., Evaluation model of time-varying availability for combat units under finite repair capacity, Journal of National University of Defense Technology, 38, 1, pp. 114-121, (2016)
[4] Ruan M Z, Peng Y W, Li Q M, Et al., Optimization of three-echelon inventory project for equipment spare parts based on system support degree, Systems Engineering-Theory & Practice, 32, 7, pp. 1624-1630, (2012)
[5] Cai Z M, Jin J S, Li G B., Warship spare parts allotment optimization method under multi-constraints, Systems Engineering-Theory & Practice, 35, 6, pp. 1561-1566, (2015)
[6] Cai Z M, Jin J S, Chen Y Q., Optimal inventory modeling of spare parts under the criticality, Systems Engineering and Electronics, 39, 8, pp. 1765-1773, (2017)
[7] Jiang W, Sheng W, Yang L, Et al., Spares optimization of phased array radar under the condition-based maintenance, Systems Engineering and Electronics, 39, 9, pp. 2052-2057, (2017)
[8] Wu L T, Wang T N, Ke R B, Et al., Modeling of inventory allocation of equipment repairable spare parts in two-echelon system based on (T, S) inventory policy, Acta Armamentarii, 39, 8, pp. 1632-1638, (2018)
[9] Laua H C, See C T, Cheng S Y., Evaluation of time-varying availability in multi-echelon spare parts systems with passivation, European Journal of Operational Research, 170, 1, pp. 91-105, (2006)
[10] Zhou L, Li Q M, Peng Y W, Et al., Availability evaluation modeling for K/N(G) structure system with cannibalization, Acta Aeronautica et Astronautica Sinica, 38, 4, pp. 118-127, (2017)

← 1 2 →