The Propagation Characteristics of Surface Ionization Wave in Surface Dielectric Barrier Discharge Sustained by the Nanosecond Pulse Voltage

被引:0
|
作者
Ye C. [1 ,2 ]
Huang B. [2 ]
Zhang C. [2 ,3 ]
Chen G. [1 ]
Shao T. [2 ,3 ]
机构
[1] School of Electrical Engineering, Zhengzhou University, Zhengzhou
[2] Beijing International S& T Cooperation Base for Plasma Science and Energy Conversion, Institute of Electrical Engineering, Chinese Academy of Sciences, Beijing
[3] University of Chinese Academy of Sciences, Beijing
关键词
Charge dissipate; Current decay rate; Propagation velocity; Surface dielectric barrier discharge; Surface ionization wave;
D O I
10.19595/j.cnki.1000-6753.tces.190616
中图分类号
学科分类号
摘要
Surface dielectric barrier discharge (SDBD) actuator is widely used in plasma flow control. The surface ionization wave (SIW) propagation is one of the important parameters for optimizing the control effect of the actuator. In this paper, using PTFE and epoxy resin (ER) as dielectric materials, surface dielectric barrier discharge actuator with multi-GND electrode array structure was fabricated. The propagation characteristics of surface ionization wave in the surface dielectric barrier discharge were studied experimentally using nanosecond high voltage pulse power supply. The experimental results show that at the rising edge of the pulse voltage, two breakdowns occur, forming a discharge channel, namely the primary ionization wave and the secondary ionization respectively. There are two peaks on the current curve, the first peak indicates the primary ionization wave, and the second peak indicates the secondly ionization wave. The charge distribution and evolution are obtained by integrating the current curves at different positions. It is found that the charge electrode dissipates faster near the high voltage, while electrode dissipates more slowly when the charge far away from the high voltage. Moreover, the charge residual of PTFE medium is obvious after discharge, but that of ER medium is not obvious. In addition, the effects of applied voltage amplitude and repetition frequency on SIW propagation characteristics were studied. With a constant voltage amplitude (14kV), the repetition frequency has little influence on the propagation speed of SIW in the range of 100~1 000Hz, but the decay speed of SIW is faster with the increase of the repetition. With a constant repetition frequency (500Hz), when the voltage amplitude changes from 8kV to 17kV, it is found that the voltage amplitude has little influence on the decay of SIW, but the propagation speed of SIW increases with the increase of the voltage amplitude. The results are helpful to the optimize the discharge parameters of SDBD actuator. © 2020, Electrical Technology Press Co. Ltd. All right reserved.
引用
收藏
页码:2652 / 2661
页数:9
相关论文
共 28 条
  • [1] Shao Tao, Zhang Cheng, Wang Ruixue, Et al., Atmospheric-pressure pulsed gas discharge and pulsed plasma application, High Voltage Engin- eering, 42, 3, pp. 685-705, (2016)
  • [2] Dai Dong, Ning Wenjun, Shao Tao, A review on the state of art and future trends of atmospheric pressure low temperature plasmas, Transactions of China Electrotechnical Society, 32, 20, pp. 1-9, (2017)
  • [3] Gao Yuan, Zhang Shuai, Sun Hao, Et al., Highly efficient conversion of methane using microsecond and nanosecond pulsed spark discharges, Applied Energy, 226, pp. 534-545, (2018)
  • [4] Li Heping, Yu Daren, Sun Wenting, Et al., State- of-the-art of atmospheric discharge plasmas, High Voltage Engineering, 42, 12, pp. 3697-3727, (2016)
  • [5] Nie Wansheng, Zhou Siyin, Che Xueke, Review of plasma assisted combustion technology by nano- second pulsed discharge, High Voltage Engin- eering, 43, 6, pp. 1749-1758, (2017)
  • [6] Shi Yaowei, Zhou Ruoyu, Cui Xinglei, Et al., Experimental investigation on characteristics of coplanar dielectric barrier discharge driven by different power supplies, Transactions of China Electrotechnical Society, 33, 22, pp. 5371-5380, (2018)
  • [7] Shao Tao, Yan Ping, Zhang Shichang, Et al., Review on nanosecond-pulse discharge mechanism in gases, High Power Laser and Particle Beams, 20, 11, pp. 1928-1932, (2008)
  • [8] Xie Qing, Gan Wenyan, Zhang Cheng, Et al., Effect of rise time on nanosecond pulsed surface dielectric barrier discharge actuator, IEEE Transactions on Dielectrics and Electrical Insulation, 26, 2, pp. 346-352, (2019)
  • [9] Kotsonis M., Diagnostics for characterisation of plasma actuators, Measurement Science and Tech- nology, 26, 9, (2015)
  • [10] Lagarkov A N, Rutkevich I M., Ionization waves in electrical breakdown of gases, (1994)