Preparation of pyrolysis products by catalytic pyrolysis of poplar: Application of biochar in antibiotic wastewater treatment

被引：50

作者：

Qin X. ^{[1
]}

Cheng S. ^{[2
,3
]}

Xing B. ^{[2
,3
]}

Qu X. ^{[2
]}

Shi C. ^{[2
,3
]}

Meng W. ^{[2
]}

Zhang C. ^{[2
,3
]}

Xia H. ^{[4
]}

机构：

[1] School of Surveying and Land Information Engineering, Henan Polytechnic University, Jiaozuo

[2] College of Chemistry and Chemical Engineering, Henan Polytechnic University, Jiaozuo

[3] Collaborative Innovation Center of Coal Work Safety and Clean High Efficiency Utilization, Jiaozuo

[4] Faculty of Metallurgical and Energy Engineering, Kunming University of Science and Technology, Yunnan, Kunming

来源：

Chemosphere | 2023年 / 338卷

基金：

中国国家自然科学基金;

关键词：

Adsorption; Biochar; Energy storage; Poplar waste; Pyrolysis;

D O I：

10.1016/j.chemosphere.2023.139519

中图分类号：

学科分类号：

摘要：

Poplar waste is acted as feedstock to produce renewable biofuel and green chemical by catalytic pyrolysis using ferric nitrate and zinc chloride as additive. The additive contributes to the generation of furfural in bio-oil. Additive promotes the generation of H2 and inhibits the generation of CO with bio-gas heating value of 12.16 MJ (Nm3)−1. Biochar exists ZnO and Fe3O4 with large surface area, which could be used as absorbent and photocatalyst for tetracycline and ciprofloxacin removal. The tetracycline and ciprofloxacin adsorption amount of biochar are 316.41 and 255.23 mg g−1 respectively. While the photocatalytic degradation removal of the tetracycline and ciprofloxacin is close to 100%. The adsorption and photocatalytic degradation mechanism are investigate and analyzed using the density functional theory and electron paramagnetic resonance analysis. Biochar can be quickly recycled and regenerated after use. Besides, biochar can be used in lithium ion battery industry for energy storage, which specific capacity is 535 mAh g−1. © 2023 Elsevier Ltd

引用

共 48 条

[1]

Abd El-Monaem E.M., Omer A.M., El-Subruiti G.M., Mohy-Eldin M.S., Eltaweil A.S., Zero-valent iron supported-lemon derived biochar for ultra-fast adsorption of methylene blue, Biomass Convers. Bio., 23, pp. 11-21, (2022)

[2]

Arica T.A., Kuman M., Gercel O., Ayas E., Poly(dopamine) grafted bio-silica composite with tetraethylenepentamine ligands for enhanced adsorption of pollutants, Chem. Eng. Res. Des., 141, pp. 317-327, (2019)

[3]

Arica T.A., Balci F.M., Balci S., Arica M.Y., Highly porous poly(o-phenylenediamine) loaded magnetic carboxymethyl cellulose hybrid beads for removal of two model textile dyes, Fibers Polym., 23, 10, pp. 2838-2854, (2022)

[4]

Aysu T., Durak H., Catalytic pyrolysis of liquorice (Glycyrrhiza glabra L.) in a fixed-bed reactor: effects of pyrolysis parameters on product yields and character, J. Anal. Appl. Pyrolysis, 111, pp. 156-172, (2015)

[5]

Bai X., Li J., Jia C., Shao J., Yang Q., Chen Y., Yang H., Wang X., Chen H., Preparation of furfural by catalytic pyrolysis of cellulose based on nano Na/Fe-solid acid, Fuel, 258, (2019)

[6]

Bayramoglu G., Aric M.Y., Grafting of regenerated cellulose flms with fbrous polymer and modified into phosphate and sulfate groups: application for removal of a model azo-dye, Colloid. Surface., 614, (2021)

[7]

Bayramoglu G., Kunduzcu G., Arica M.Y., Preparation and characterization of strong cation exchange terpolymer resin as effective adsorbent for removal of disperse dyes, Polym. Eng. Sci., 60, 1, pp. 92-201, (2019)

[8]

Cardoso C.R., Ataide C.H., Micropyrolysis of tobacco powder at 500 degrees C: influence of ZnCl<sub>2</sub> and MgCl<sub>2</sub> contents on the generation of products, Chem. Eng. Commun., 202, 4, pp. 484-492, (2015)

[9]

Cheng S., Xing B.L., Shi C.L., Nie Y.H., Xia H.Y., Efficient and selective removal of Pb(II) from aqueous solution by modifcation crofton weed: experiment and density functional theory calculation, J. Clean. Prod., 280, (2021)

[10]

Cheng S., Meng M.L., Xing B.L., Shi C.L., Nie Y.H., Xia D.P., Yi G.Y., Zhang C.X., Xia H.Y., Preparation of valuable pyrolysis products from poplar waste under different temperatures by pyrolysis: evaluation of pyrolysis products, Bioresour. Technol., 364, (2022)

← 1 2 3 4 5 →