Drive-control modes of six-phase PMSM

被引：0
|
作者：
Kuang X. [1 ]
Xu J. [2 ]
Huang C. [3 ]
Li J. [1 ]
Guo H. [2 ]
机构：
[1] Beijing Mechanical Equipment Institute, Beijing
[2] School of Automation Science and Electrical Engineering, Beihang University, Beijing
[3] The Military Representative Office of the PLA in the Institute 206 of the 2nd Research Academy of CASIC, Beijing
来源：
Beijing Hangkong Hangtian Daxue Xuebao/Journal of Beijing University of Aeronautics and Astronautics | 2019年 / 45卷 / 07期
关键词：
Drive-control; Fault-tolerant; Permanent magnet synchronous motor (PMSM); Redundant; Reliability;
D O I：
10.13700/j.bh.1001-5965.2018.0695
中图分类号：
学科分类号：
摘要：
The drive-control modes of multi-phase permanent magnet synchronous motor (PMSM) consist of the redundant mode and fault-tolerant mode. To research the difference of multi-phase PMSM performance caused by drive-control modes, a redundant PMSM system and a fault-tolerant PMSM system are built respectively based on a six-phase PMSM. On this basis, the influence mechanism and influence law of the redundant and fault-tolerant drive-control modes on the six-phase PMSM system performance are studied, including the speed range and dynamic performance. Simulation and experimental results show that, compared with the redundant drive-control mode, the six-phase PMSM with fault-tolerant drive-control mode has wider speed range and better dynamic performance. © 2019, Editorial Board of JBUAA. All right reserved.
引用
收藏
页码：1361 / 1369
页数：8
相关论文
共 22 条
  • [1] Haskew T.A., Schinstock D.E., Optimal design of electromechanical actuators for active loads, IEEE/ASME Transactions on Mechatronics, 3, 2, pp. 129-137, (1998)
  • [2] Lyshevski S.E., Electromechanical flight actuators for advanced flight vehicles, IEEE Transactions on Aerospace and Electronic Systems, 35, 2, pp. 511-518, (1999)
  • [3] Gerada C., Bradley K.J., Integrated PM machine design for an aircraft EMA, IEEE Transactions on Industrial Electronics, 55, 9, pp. 3300-3306, (2008)
  • [4] Woodburn D., Wu T., Zhou L., Et al., High-performance electromechanical actuator dynamic heat generation modeling, IEEE Transactions on Aerospace and Electronic Systems, 50, 1, pp. 530-541, (2014)
  • [5] Sha N.S., Li J., Research on airborne power-by-wire integrated electrical actuation and control systems, Journal of Beijing University of Aeronautics and Astronautics, 30, 9, pp. 909-912, (2004)
  • [6] Guo H., Xing W., Development of electromechanical actuators, Acta Aeronautica et Astronautica Sinica, 28, 3, pp. 620-627, (2007)
  • [7] Zhou Y.J., Zhao Y.K., Ge Y.H., Fault-tolerant control method and characteristic analysis of hydraulic redundant EMA system, Journal of Beijing University of Aeronautics and Astronautics, 34, 3, pp. 285-289, (2008)
  • [8] Barrero F., Arahal M.R., Gregor R., Et al., A proof of concept study of predictive current control for VSI-driven asymmetrical dual three-phase AC machines, IEEE Transactions on Industrial Electronics, 56, 6, pp. 1937-1954, (2009)
  • [9] Kallio S., Karttunen J., Peltoniemi P., Et al., Online estimation of double-star IPM machine parameters using RLS algorithm, IEEE Transactions on Industrial Electronics, 61, 9, pp. 4519-4530, (2014)
  • [10] Mecrow B.C., Jack A.G., Atkinson D.J., Et al., Design and testing of a four-phase fault-tolerant permanent-magnet machine for an engine fuel pump, IEEE Transactions on Energy Conversion, 19, 4, pp. 671-678, (2004)
123