Influence of sine micro groove texture on the tribological performance of plunger seal pair

被引：0
作者：
Du W.-X. [1 ]
He X. [1 ]
Chen W.-B. [2 ]
Wang G.-R. [1 ]
Zhong L. [1 ]
机构：
[1] School of Mechanical Engineering, Southwest Petroleum University, Chengdu
[2] CNPC Chuanqing Drilling Engineering Company Limited, Chengdu
来源：
Surface Technology | 2021年 / 50卷 / 07期
基金：
中国国家自然科学基金;
关键词：
Fracturing pump; Lubrication and friction reduction; Plunger sealing pair; Sine groove; Surface texture;
D O I：
10.16490/j.cnki.issn.1001-3660.2021.07.023
中图分类号：
学科分类号：
摘要：
The purpose of this paper is to reduce the friction and wear of the plunger sealing pair of the fracturing pump, and study the influence of the sine groove texture on the friction performance of the plunger sealing pair under different working conditions. Based on the geometric model of the plunger sealing pair of the fracturing pump and the fluid lubrication theory, a numerical theoretical model of the sine micro-groove textured plunger-rubber sealing pair is established to study the effect of different plunger sealing pressures and stroke times on the anti-wear performance of sine texture through simulation. Under different sealing pressure, from 40 MPa to 140 MPa, the oil film bearing capacity and its growth rate of textured plunger surface increase, the friction coefficient increases and the growth rate decreases, and the higher the plunger stroke, the greater the oil film bearing capacity and friction coefficient; under different plunger stroke (speed), the oil film bearing capacity and plunger speed have a linear relationship, the friction coefficient increases and the growth rate decreases; according to the simulation results, it can be seen that the oil film bearing capacity is the largest and the friction coefficient is the minimum under the condition of plunger stroke sealing pressure 150/min-80 MPa, while the oil film bearing capacity and friction coefficient are the minimum under the condition of 300/min-40 MPa. The sine groove texture can effectively improve the dynamic pressure lubrication performance of the plunger seal pair. Under the sine groove texture parameters of this article, with the increase of the plunger seal pressure and stroke rate, the oil film bearing capacity and friction coefficient both show an increase trend. © 2021, Chongqing Wujiu Periodicals Press. All rights reserved.
引用
收藏
页码：225 / 232
页数：7
相关论文
共 30 条
[1]  
Ling Y., Li X.-W., Mu L.-J., Et al., New progress in fracturing technologies for tight sandstone gas reservoirs in the Sulige gas field, ordos basin[J], Natural gas industry, 34, 11, pp. 66-72, (2014)
[2]  
Xu H.-L., Ma T.-S., Peng N., Et al., Influences of fracturing fluid injection on mechanical integrity of cement sheath under four failure modes[J], Energies, 11, 12, (2018)
[3]  
Huang Z.-Q., Li Q., Zhou X.-R., Et al., Study on plunger-seal pair in fracturing pump [J], Oil field equipment, 29, 6, pp. 9-12, (2000)
[4]  
Zhang Z.-L., Zhu W.-B., Failure analysis of the plunger of plunger pump OPI-1800AWS[J], Sichuan University of Science and Technology(natural science edition), 24, 5, pp. 26-28, (2005)
[5]  
Pei Y.T., Bui X.L., Zhou X.B., Et al., Tribological behavior of W-DLC coated rubber seals[J], Surface and coatings technology, 202, 9, pp. 1869-1875, (2008)
[6]  
Segu D.Z., NBR surface modification by Ar plasma and its tribological properties[J], Industrial lubrication and tribology, 68, 2, pp. 227-232, (2016)
[7]  
Li Y.-L., Wang S.-J., Wang Q., Et al., Molecular dynamics simulations of tribology properties of NBR (Nitrile-Butadiene Rubber) /carbon nanotube composites[ J], Composites part B: Engineering, 97, pp. 62-67, (2016)
[8]  
Li Y.-Q., Wang Q.-H., Wang T.-M., Et al., Preparation and tribological properties of graphene oxide/nitrile rubber nanocomposites[J], Journal of materials science, 47, 2, pp. 730-738, (2012)
[9]  
Wang L.-L., Zhang L.-Q., Tian M., Effect of expanded graphite (EG) dispersion on the mechanical and tribological properties of nitrile rubber/EG composites[J], Wear, 276-277, pp. 85-93, (2012)
[10]  
Maciel A.V., Machado J.C., Pasa V.M.D., The effect of temperature on the properties of the NBR/PVC blend exposed to ethanol fuel and different gasolines[J], Fuel, 113, pp. 679-689, (2013)
123