ARDUINO-BASED MAXIMUM POWER POINT TRACKING CHARGE CONTROLLER USING PERTURB & OBSERVE AND CONSTANT-VOLTAGE ALGORITHMS

被引：0
作者：
Ilori O.A. [1 ]
Willoughby A.A. [1 ]
Dairo O.F. [1 ,2 ]
Osinowo M.O. [1 ]
Ewetumo T. [3 ]
机构：
[1] Department of Physical Sciences, Faculty of Natural Sciences, Redeemer’s University, Osun State, Ede
[2] Department of Electrical and Electronic Engineering, Faculty of Engineering, Redeemer’s University, Osun State, Ede
[3] Department of Physics, Federal University of Technology, Ondo State, Akure
来源：
International Journal of Energy for a Clean Environment | 2023年 / 24卷 / 07期
关键词：
constant voltage; DC-DC converter; MATLAB/Simulink; maximum power point tracking; observe; perturb;
D O I：
10.1615/INTERJENERCLEANENV.2022044065
中图分类号：
学科分类号：
摘要：
The output power delivered by a photovoltaic (PV) module to charge a battery is dependent on solar radiation incident upon it and the ambient temperature. To reduce PV energy loss, the PV panel is kept at peak efficiency by operating the PV system at the maximum power point (MPP) to deliver maximum power to the battery under charge. In this work, Perturb & Observe (P&O) algorithm was implemented in conjunction with constant voltage (CV), using the MATLAB/Simulink tool. Results obtained from these simulations show that the tracking efficiency of the P&O algorithm decreases with solar irradiation. However, the relatively good performance of the CV algorithm at low irradiation levels augments the P&O method. Both algorithms were implemented in a maximum power point tracking (MPPT) design using an ATMega328 microcontroller operating on a minimal Arduino-compatible integrated development environment (IDE) prototype circuit. © 2023 by Begell House, Inc.
引用
收藏
页码：115 / 134
页数：19
相关论文
共 64 条
  • [1] Abdelilah B., Mourna A., KouiderM'Sirdi N., El Houssain A., Implementation of Maximum Power Point Tracking (MPPT) Solar Charge Controller Using Arduino, IOP Conf. Ser.: Mater. Sci. Eng, 353, (2009)
  • [2] Aboudane H., Fakkar A., Elkouari Y., Ouoba D., Performance of a New MPPT Method for PV Systems under Dynamic Solar Irradiation Profiles, Energy Procedia, 142, pp. 538-544, (2017)
  • [3] Abuzairi T., Ramadhan W.W.A., Devara K., Solar Charge Controller with Maximum Power Point Tracking for Low Power Applications, Int. J. Photoenergy, 2019, (2019)
  • [4] Acharya P.S., Aithal P.S., A Comparative Study of MPPT and PWM Solar Charge Controllers and Their Integrated System, J. Phys. Conf. Ser, 1712, (2020)
  • [5] Aganah K.A., Leedy A.W., A Constant Voltage Maximum Power Point Tracking Method for Solar Powered Systems, IEEE 43rd Southeast. Symp. Theory, pp. 125-130, (2011)
  • [6] Akash G., Saida R., Sushma G., Comparison of P&O and Fuzzy Logic Controller in MPPT for Photovoltaic (PV) Applications by Using MATLAB/Simulink, IOSR J. Electron. Electron. Eng, 10, 4, pp. 53-62, (2015)
  • [7] Algarin C.A., Giraldo J.T., Alvarez O.R., Fuzzy Logic Based MPPT Controller for a PV System, Energies, 10, 12, (2017)
  • [8] Ali R.R., Mohammad H.M., Shahriar J., Classification and Comparison of Maximum Power Point Tracking Techniques for Photovoltaic System: A Review, Renew. Sustain. Energy Rev, 19, pp. 433-443, (2013)
  • [9] Altas I.H., Sharaf A.M., A Novel Maximum Power Fuzzy Logic Controller for Photovoltaic Energy Systems, Renew. Energy, 33, 3, pp. 388-399, (2008)
  • [10] Anada-Rao K., Matar Y., Baharudin N.H., Ismail M.A., Abdullah A.M., Design of MPPT Charge Controller Using Zeta Converter for Battery Integrated with Solar Photovoltaic (PV) System, J. Phys.: Conf. Ser, 1432, 1, (2020)
1234567