Design of low EMI and high efficiency BUCK converter based on frequency jittering technology

被引:0
作者
Ning K. [1 ]
Liu R. [1 ]
Dai L. [1 ]
Sun H. [1 ]
机构
[1] Information College, North China University of Technology, Beijing
来源
Huazhong Keji Daxue Xuebao (Ziran Kexue Ban)/Journal of Huazhong University of Science and Technology (Natural Science Edition) | 2022年 / 50卷 / 03期
关键词
Alterable threshold; Bandgap reference; BUCK converter; Electromagnetic interference (EMI); Frequency jitter; High efficiency; Oscillator;
D O I
10.13245/j.hust.220302
中图分类号
学科分类号
摘要
A low electromagnetic interference (EMI), high efficiency BUCK and low area consumption converter chip based on frequency jittering technology was presented. In the frequency jittering oscillator, an amplifying and sampling circuits were adopted to change the voltage of oscillator capacitor effectively and achieved less capacitor application, which can effectively reduce the area of the integration capacitor, especially it reduced the electromagnetic interference and solved the EMI problem. Meanwhile, it optimized the circuits in this chip and improved efficiency. Finally, it was implemented in 0.35 μm BCD (binary-coded decimal) process. And the measurement results are bellows, in the condition of the radiated emission test according to CISPR 25 ALSE method, the maximum value of EMI peak value and average value is 30 and 20 dB·μV respectively with the frequency range between 30~1 000 MHz, and are far below the limitation of CISPR 25 ALSE, furthermore, it achieves a high efficiency of 95%. © 2022, Editorial Board of Journal of Huazhong University of Science and Technology. All right reserved.
引用
收藏
页码:7 / 11
页数:4
相关论文
共 15 条
[1]  
KHAN A, CHA H., Dual-buck-structured high-reliability and high-efficiency single-stage buck-boost inverters, IEEE Transactions on Industrial Electronics, 65, 4, pp. 3176-3187, (2018)
[2]  
ABDULSLAM A, PATRICK P, MERCIER A., Passive- stacked third-order buck converter with inherent input filtering achieving 0.7 W/mm<sup>2</sup> power density and 94% peak efficiency, IEEE Solid-State Circuits Letters, 2, 11, pp. 240-243, (2019)
[3]  
CHANG R, CHEN W, HUANG J., A 93.4% efficiency 8 mV offset voltage constant on-time buck converter with an offset cancellation technique, IEEE Transactions on Circuits and Systems II, 67, 10, pp. 2069-2073, (2020)
[4]  
SHIRAI R, SHIMIZU T., Study of EMI caused by buck converter on controller area network, Proc of International Power Electronics Conference, pp. 3309-3314, (2018)
[5]  
ARUNA P, PREMALATHA L., Investigation of EMI reduction in buck converter by using external chaos generator, Proc of International Conference of Electrical, Electronics and Control Enginerring, pp. 520-525, (2011)
[6]  
KAM K, POMMERENKE D, LAM C, Et al., EMI analysis methods for synchronous buck converter EMI Root cause analysis, Proc of International Symposium on Electromagnetic Compatibility, pp. 1-7, (2008)
[7]  
CHEN Z, XIE S, LAUN S, Et al., EMI spectrum identification and suppression methods for synchronous buck converter, Proc of International Applied Computational Electromagnetics Society Symposium, pp. 1-5, (2019)
[8]  
PARK S, HUYNH H, KIM S., Analysis of EMI reduction methods of DC-DC buck converter, Proc of International Workshop on the Electromagnetic Compatibility of Integrated Circuits, pp. 92-96, (2015)
[9]  
XUE J, LEE H., A 2 MHz 12-100 V 90% efficiency self-Balancing ZVS reconfigurable three-level DC-DC regulator with constant-frequency adaptive-on-time V<sup>2</sup> control and nanosecond-scale ZVS turn-on delay, IEEE Journal of Solid-state Circuits, 51, 12, pp. 2854-2866, (2016)
[10]  
MUKHERJEE R, PATRA A, BANERJEE S., A chaos-modulated ramp generator IC for flexible EMI reduction in voltage-mode controlled PWM buck converters, Proc of International Symposium on Integrated Circuits, pp. 410-413, (2007)