Instability prediction of valve motion and internal flow in novel large-scale reciprocating pump

被引：3

作者：

Ma Y. ^{[1
]}

Chen Y. ^{[1
]}

Zhang H. ^{[2
]}

Luo H. ^{[1
]}

Deng H. ^{[1
]}

机构：

[1] College of Mechanical Engineering, Zhejiang University of Technology, 288 Liuhe Road, Hangzhou

[2] Ningbo Tongli Pump Industry Co., Ltd, 888 Chengxin Road, Ningbo

来源：

International Journal of Fluid Machinery and Systems | 2019年 / 12卷 / 01期

基金：

中国国家自然科学基金;

关键词：

Dynamic grid technique; Flow pulsation; Instability prediction; Reciprocating pump; Valve motion;

D O I：

10.5293/IJFMS.2019.12.1.001

中图分类号：

学科分类号：

摘要：

To study the transient valve motions and flow pulsation of novel five-cylinder double-acting reciprocating pump, the theoretical analysis and computational fluid dynamics (CFD) method are employed to investigate the full-cycle working process of the pump. The theoretical models describing the motions and flow rates of hydraulic end are established for reciprocating pump under the actions of piston and valves. The open-close behavior of suction and discharge valves, internal turbulent flow and pulsation characteristics of the pump are studied and the effects of crank speed on those are analyzed in detail. The results show that the valves of reciprocating pump open and close quickly and non-linearly with various degrees of striking velocities and lag phenomena. Through the time and frequency domain results of flow pulsation, the single-cavity frequency is the dominant frequency. The most obvious amplitude appears for discharge flow pulsation, which gradually increases with crank speed. The results could provide useful information for the optimization of reciprocating pumping systems. © 2019, Turbomachinery Society of Japan. All rights reserved.

引用

页码：1 / 11

页数：10

共 20 条

[1]

Opitz K., Schlucker E., Detection of Cavitation Phenomena in Reciprocating Pumps Using a High-speed Camera, Chemical Engineering & Technology, 33, 10, pp. 1610-1614, (2010)

[2]

Hong S., Lee B., Cho Y., Improvement of Lubrication Characteristics in the Reciprocating Fuel Pump of Marine Diesel Engines, Journal of Mechanical Science and Technology, 30, 11, pp. 5225-5232, (2016)

[3]

Zhang H., Liang Y., Zhou X., Yan X., Qian C., Liao Q., Sensitivity Analysis and Optimal Operation Control for Large-scale Waterflooding Pipeline Network of Oilfield, Journal of Petroleum Science and Engineering, 154, 6, pp. 38-48, (2017)

[4]

Landelle A., Tauveron N., Revellin R., Haberschill P., Colasson S., Roussel V., Performance Investigation of Reciprocating Pump Running with Organic Fluid for Organic Rankine Cycle, Applied Thermal Engineering, 113, 2, pp. 962-969, (2017)

[5]

Li Q., Liu J., Fu J., Zhou X., Liao C., “Comparative Study on the Pumping Losses between Continuous Variable Valve Lift (CVVL) Engine and Variable Valve Timing (VVT) Engine, Applied Thermal Engineering, 137, 5, pp. 710-720, (2018)

[6]

The Y.L., Ooi K.T., Djamari D.W., Theoretical Study of a Novel Refrigeration Compressor--Part II: Performance of a Rotating Discharge Valve in the Revolving Vane (RV) Compressor, International Journal of Refrigeration, 32, 5, pp. 1103-1111, (2009)

[7]

Rotta J.L., Pinilla A., Performance Evaluation of a Commercial Positive Displacement Pump for Wind-water Pumping, Renewable Energy, 32, 10, pp. 1790-1804, (2007)

[8]

Silva L.R., Deschamps C.J., Modeling of Gas Leakage through Compressor Valves, International Journal of Refrigeration, 53, 5, pp. 195-205, (2015)

[9]

Guerra C.J., Kolodziej J.R., A Data-driven Approach for Condition Monitoring of Reciprocating Compressor Valves, Journal of Engineering for Gas Turbines & Power, 136, 4, (2014)

[10]

Wang Y., Gao A., Zheng S., Peng X., Experimental Investigation of the Fault Diagnosis of Typical Faults in Reciprocating Compressor Valves, Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 230, 13, pp. 2285-2299, (2016)

← 1 2 →