Effect of TiO2 on Thermal Shock Resistance and Slag Penetration Resistance of Magnesia

被引：0
|
作者：
Li Z. [1 ]
Xu Y. [1 ]
Wang Q. [1 ]
Zhu T. [1 ]
Dai Y. [1 ]
Zhou F. [2 ]
Xu C. [2 ]
机构：
[1] The State Key Laboratory of Refractories and Metallurgy, Wuhan University of Science and Technology, Wuhan
[2] Wugang Refractory Co. Ltd., Wuhan
来源：
Kuei Suan Jen Hsueh Pao/Journal of the Chinese Ceramic Society | 2023年 / 51卷 / 03期
关键词：
free calcium oxide; hydration resistance; magnesium oxide; slag penetration resistance; thermal shock resistance; titanium oxide;
D O I：
10.14062/j.issn.0454-5648.20220867
中图分类号：
学科分类号：
摘要：
To improve the resistance to hydration, thermal shock and slag penetration of magnesia, a magnesia based composite was prepared via adding TiO2 powder (i.e., 1% (in mass fraction), 2% and 3%) into a light burned magnesia powder. The effect of TiO2 content on the sintering behavior, microstructure and properties of the composite was investigated. The results show that free CaO and some MgO transform into CaTiO3 and Mg2TiO4 and the size of MgO grains increases as TiO2 addition increases, leading to an improvement in the hydration resistance. The formed CaTiO3 and Mg2TiO4 phases reduce the thermal expansion coefficient and induce the crack deflection as TiO2 content increases, therefore improving the thermal shock resistance of the specimens. Besides, as 1% TiO2 is added, the slag penetration resistance of the specimens is enhanced due to the increase in MgO grain size and the formation of high stable intergranular CaTiO3 phase. However, the further increasing TiO2 content reduces the slag penetration resistance due to the formation of low stable Mg2TiO4 phase at MgO grain boundaries. © 2023 Chinese Ceramic Society. All rights reserved.
引用
收藏
页码：602 / 609
页数：7
相关论文
共 31 条
  • [1] CHEN Yang, DENG Chengji, WANG Xing, Et al., J Chin Ceram Soc, 47, 12, pp. 1834-1840, (2019)
  • [2] JIN E D, YU J K, WEN T P, Et al., Fabrication of high-density magnesia using vacuum compaction molding[J], Ceram Int, 44, 6, pp. 6390-6394, (2018)
  • [3] ZHANG Ningxuan, XIAO Guoqing, DUAN Feng, Et al., J Chin Ceram Soc, 49, 9, pp. 2025-2035, (2021)
  • [4] CHEN L G, LI S L, JONES P T, Et al., Identification of magnesia–chromite refractory degradation mechanisms of secondary copper smelter linings[J], J Eur Ceram Soc, 36, 8, pp. 2119-2132, (2016)
  • [5] CHEN M, LU C Y, YU J K., Improvement in performance of MgO–CaO refractories by addition of nano-sized ZrO<sub>2</sub>[J], J Eur Ceram Soc, 27, 16, pp. 4633-4638, (2007)
  • [6] GRUBER D, SISTANINIA M, FASCHING C, Et al., Thermal shock resistance of magnesia spinel refractories-investigation with the concept of configurational forces[J], J Eur Ceram Soc, 36, 16, pp. 4301-4308, (2016)
  • [7] WAGNER C, WENZL C, GREGUREK D, Et al., Thermodynamic and experimental investigations of high-temperature refractory corrosion by molten slags[J], Metall Mater Trans B, 48, pp. 119-131, (2017)
  • [8] CHEN L G, GUO M X, SHI H Y, Et al., Influence of FeO/SiO<sub>2</sub> and CaO/SiO<sub>2</sub> ratios in iron-saturated ZnO-rich fayalite slags on the corrosion of MgO[J], J Am Ceram Soc, 99, pp. 3754-3760, (2016)
  • [9] SONG Yuhai, Refractories, 2, (2014)
  • [10] Ding J, Yuan W J, Li J, Et al., Preparation and hydration resistance of MgO–MgAl<sub>2</sub>O<sub>4</sub> composite refractory[J], Adv Mater Res, pp. 851-854, (2012)
1234