Influence of mineral composition and grain size on mechanical properties of marble

被引：0
作者：
Xie X. [1 ]
Cheng Y. [1 ]
Li S. [2 ]
Chen X. [1 ]
机构：
[1] Faculty of Engineering, China University of Geosciences(Wuhan), Hubei, Wuhan
[2] China Railway Siyuan Survey and Design Institute Group Co. Ltd, Hubei, Wuhan
来源：
Yanshilixue Yu Gongcheng Xuebao/Chinese Journal of Rock Mechanics and Engineering | 2024年 / 43卷 / 1 S期
基金：
中国国家自然科学基金;
关键词：
grain size; marble; mechanical properties; mineral composition; rock mechanics; variation of confining pressure;
D O I：
10.13722/j.cnki.jrme.2022.1047
中图分类号：
学科分类号：
摘要：
To understand the effect of mineral composition and grain size on mechanical properties of rock better,the basic data of mineral composition,mineral micro-mechanical properties,grain size and shape of four kinds of marble are obtained in this paper. Then their strength parameters,deformation properties and failure modes are tested for further analysis. The results indicate that:(1) The strength of Chenzhou,Fangshan,Carrara and Hezhou marble decreases while their ductility increases in sequence,that is,the strength and brittleness of dolomite marble is greater than that of calcite marble. (2) Considering only the effect of grain size,the strength and brittleness of rock decreases with increasing grain size. However,when considering other factors(mineral composition,micro-mechanical properties) together,it is possible that rocks consisting of larger grains present a higher strength and more brittle behavior. (3) The cohesion of rock is positively and linearly correlated with uniaxial compressive strength,while it is weakly correlated with tensile strength. (4) The ratios of uniaxial compressive strength to tensile strength are significantly different from that predicted by the extended Griffith theory,while the ratios of crack initiation stress to tensile strength maintain around 7–12. (5) During triaxial compression test,the confining pressure fluctuates slightly above the target value,and the overall synchronization exists between the variation of the confining pressure and the axial stress. The results not only enhance the understanding of mineral grain size effect and enrich the theoretical knowledge of rock mechanics,but also provide a large number of basic data for further marble engineering evaluation and calculation analysis. © 2024 Academia Sinica. All rights reserved.
引用
收藏
页码：3280 / 3295
页数：15
相关论文
共 72 条
[1]  
ALBER M H U., Generation and visualization of microfractures in Carrara marble for estimating fracture toughness,fracture shear and fracture normal stiffness[J], International Journal of Rock Mechanics and Mining Sciences, 36, 8, pp. 1065-1071, (1999)
[2]  
MAHMUTOGLU Y, SANS G., Comparison of post-failure strength of micro-cracked marble with Hoek-Brown failure criterion[J], Pamukkale Üniversitesi Mühendislik Bilimleri Dergisi, 26, 8, pp. 1365-1372, (2020)
[3]  
ROTONDA T, WITTKE W., Mechanical behaviour of an artificially microcracked marble, Proceedings of the Congress of the International Society for Rock Mechanics, pp. 345-350, (1991)
[4]  
CHENG Y, WONG L N Y., A study on mechanical properties and fracturing behavior of Carrara marble with the flat-jointed model[J], International Journal for Numerical and Analytical Methods in Geomechanics, 44, 6, pp. 803-822, (2020)
[5]  
BROOKS Z, ULM F J, EINSTEIN H H., Environmental scanning electron microscopy(ESEM) and nanoindentation investigation of the crack tip process zone in marble[J], Acta Geotechnica, 8, 3, pp. 223-245, (2013)
[6]  
HOLCOMB D J, RUDNICKI J W., Inelastic constitutive properties and shear localization in Tennessee Marble[J], International Journal for Numerical and Analytical Methods in Geomechanics, 25, 2, pp. 109-129, (2001)
[7]  
OLSSON W A., Development of anisotropy in the incremental shear moduli for rock undergoing inelastic deformation[J], Mechanics of Materials, 21, 3, pp. 231-242, (1995)
[8]  
SHAO J F, RUDNICKI J W., A microcrack-based continuous damage model for brittle geomaterials[J], Mechanics of Materials, 32, 10, pp. 607-619, (2000)
[9]  
ZHENG Huakang, HU Chao, SHANG Qin, Et al., Experimental study on mechanical behaviors of Jinping marble and its numerical modeling[J], Yangtze River, 49, 4, pp. 75-82, (2018)
[10]  
ZHAO J, FENG X, YANG C, Et al., Differential time-dependent fracturing and deformation characteristics of Jinping marble under true triaxial stress[J], International Journal of Rock Mechanics and Mining Sciences, 138, (2021)
12345678