Factors, Mechanisms, and Kinetics of Spontaneous Emulsification for Heavy Oil-in-Water Emulsions

In challenging reservoirs where thermal recovery falls short, cold or chemical oil recovery methods are crucial. Spontaneous emulsification (SE), triggered by gentle disturbance, significantly enhances oil recovery. In elucidating SE mechanisms and kinetics, SE processes via direct contact between oil and aqueous phases without stirring were conducted. The effects of temperature, emulsifier concentration, pH, NaCl concentration, and the oil-to-water ratio on SE were investigated through droplet size analysis and turbidity measurements. Furthermore, the emulsification mechanism and derived emulsification kinetics based on turbidity data were obtained. The results underscore the feasibility of SE for oil-water systems, reducing viscous and capillary resistances without agitation. The emulsified oil mass increased with the temperature, pH, and aqueous-to-oil phase volume ratio while decreasing with the NaCl concentration. In this study, for GD-2 crude oil, the optimal emulsified oil amount occurred at a betaine surfactant (BetS-2) emulsifier concentration of 0.45%. Microscopic photo analysis indicated narrow particle size distributions and small droplets, which remained stable over time under various experimental conditions. A combined SE mechanism involving ultralow interfacial tension, interfacial turbulence due to Marangoni effects, and "diffusion and stranding" due to in situ emulsifier hydrophilicity, was speculated. Additionally, an analogous second-order kinetic equation for SE was proposed, indicating exceptional correlation with calculated and experimentally measured values. This study offers theoretical insight for enhancing oil recovery in chemical and cold production of heavy oil in oilfields.