Study on the properties and components of solid-liquid products by co-pyrolysis of sludge and cotton stalk

The effects of sludge content and pyrolysis temperature on the pyrolysis process and product properties were studied through the co-pyrolysis of sludge and cotton stalk. Multi-objective fuzzy hierarchical analysis was used to analyze the multiphase properties of pyrolysis products, and describe the internal relationship between pyrolysis conditions and product properties. It has been proved using kinetic calculation that the mass ratio of sludge and cotton stalk is higher than 1:2 required the lower pyrolysis activation energy. According to the comparison between experimental and theoretical results, the addition of sludge is beneficial to increase the biooil yield. In terms of product performance, the addition of sludge and increase of pyrolysis temperature both can improve the specific surface area, pore volume of biochar and the pH value of bio-oil, reduce the total acid content, increase the total phenol content and optimize calorific value of bio-oil. The specific surface area of biochar, calorific value of bio-oil, total phenol content and pH were evaluated by multi-objective decision analysis method, the optimum process condition of sludge: cotton stalk = 2:1 at 600 degree celsius. Under the conditions, the specific surface area of biochar is 57.40 m2/g, the pH of the bio-oil is 8.06, the total acid content is 5.94 mg/g, the calorific value is 27.18 KJ/g and the total phenol content is 47.32 mg/g, respectively. Compared to the pyrolysis product of cotton stalks, the specific surface area is increased almost 20 times, the calorific value is increased by 13 %, the total acid content is decreased by 95 %, and the total phenol content is similar. This study proposed a preparation process of bio-oil with high performance, and provided a theoretical basis for the subsequent copyrolysis research.