Dynamic Voltage Balancing Across Series-Connected 10 kV SiC JBS Diodes in Medium Voltage 3L-NPC Power Converter Having Snubberless Series-Connected 10 kV SiC MOSFETs

This article addresses the mitigation of dynamic voltage imbalance in series-connected 10 kV silicon carbide (SiC) JBS diodes within a three-level NPC (3L-NPC) converter using active turn- off delay control across complementary series-connected 10 kV SiC mosfet s. The implementation of active turn- off delay control in SiC mosfet s eliminates the need for passive RC snubbers, which otherwise increase the switching dv/dt mismatch and snubber current across the diodes. In addition, parasitic base-plate capacitance across mosfet s and diodes, along with parasitic bus bar and snubber inductance in the commutation path, contribute to turn- off voltage mismatch and snubber loss in series-connected 10 kV SiC JBS diodes. The mismatch in nonlinear capacitance of series-connected devices (mosfet s and diodes) and the nonlinear mosfet i - v(gs) curve affect the turn- on and turn- off voltage transitions between complementary switching mosfet s and diodes, leading to variations in turn- off voltage mismatch and snubber losses. The 3L-NPC converter has eight types of switching transition, complicating the analysis of RC snubber design. This complexity is further increased by nonlinear device parameters, parasitic capacitance, and inductance in the commutation path for each of the eight 10 kV SiC mosfet s and four 10 kV SiC JBS diodes. To address these challenges, this research develops a mathematical model for the switching transition between 10 kV SiC mosfet s and complementary 10 kV SiC JBS diodes in a two-level clamped inductive switching (CIS) test setup. The model considers the effects of parasitic base-plate capacitance and the absence of an RC snubber due to active turn-off delay control across series-connected SiC mosfet s. Subsequently, the mathematical model is refined using an iterative algorithm to account for mismatches in nonlinear device capacitance of mosfet s and diodes, as well as the nonlinear i - v(gs) curve of mosfet s during the switching transition of the diode. This refined model is then used to design the RC snubber for series-connected 10 kV SiC JBS diodes and to optimize the turn- on gate resistance of complementary 10 kV SiC mosfet s on two-level CIS test benches (TB1 and TB2). Following this, the design parameters are systematically adjusted using experimental results from 3L-NPC test benches 3 to 5. This article provides simplified steps for the design and analysis of the RC snubber in various test benches, validated by experimental data. The 3L-NPC converter with the final RC snubber design achieved 99.2% efficiency and a 35 V turn- off voltage mismatch. The maximum error between the theoretical model and experimental data is 4.8%.