Energy based damage model for low-cycle fatigue of ductile materials

被引:0
|
作者
Perovic, Zoran B. [1 ]
Sumarac, Dragoslav M. [2 ,3 ]
Coric, Stanko B. [1 ]
Knezevic, Petar M. [4 ]
Cao, Maosen [5 ]
Nurkovic, Ismail [2 ]
机构
[1] Univ Belgrade, Fac Civil Engn, Belgrade, Serbia
[2] State Univ Novi Pazar, Dept Tech Sci, Civil Engn, Novi Pazar, Serbia
[3] Chuzhou Univ, Coll Civil & Architecture Engn, Chuzhou, Peoples R China
[4] Univ Pristina, Fac Tech Sci, Kosovska Mitrovica, Serbia
[5] Hohai Univ, Dept Engn Mech, Nanjing, Peoples R China
基金
芬兰科学院;
关键词
Failure; hysteretic energy loss; uniaxial stress state; damage evolution; PLASTIC STRAIN-ENERGY; LIFE PREDICTION; STORED ENERGY; BEHAVIOR;
D O I
10.1177/10567895241282416
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
A uniaxial material model for fatigue damage accumulation, established on the connection of unit elements, is presented in this paper. Although these units are regarded as micro-elements in the proposed model, they are based on a hysteretic operator that enables calculating hysteretic energy loss as an analytical expression. Further, this unit element represents a mechanical model with elastoplastic damage behavior in function of strain. The second level of modeling is defined by the connection of these units (micro-elements) with different values of total energy dissipated at failure. By changing the distribution of dissipated energy limit, various fatigue damage evolution laws are developed. Calculation of total and hysteretic energy loss in one loading cycle is also affected by fatigue damage as the varying number of unit elements are been eliminated when their maximum dissipation energy is reached. Material parameters for the model were defined based on the experimental monotonic and cyclic stress-strain tests, still, detailed comparison was not performed as the main advantage and aim of the paper was the development of the method for assessment of damage evolution in fatigue analysis. On the other hand, the number of cycles to failure (Nf) and total heat dissipation are compared in both qualitative and quantitative aspects with experimental results. Finally, based on the proposed model, mean strain and load sequence effect diagrams were constructed. It is shown that the proposed model can provide a reliable estimation of fatigue life in the low-cycle regime of loading. The maximum error for the calculated Nf was 3% for constant strain loading for experiments with strain amplitude less than 5%. In load sequence fatigue life estimation, the proposed model demonstrated good accuracy, with a maximum error of 34%. Further, obtained results were achieved with different types of damage evolution that could be defined for the same material and fatigue life.
引用
收藏
页码:352 / 373
页数:22
相关论文
共 50 条
  • [1] Failure Mechanisms and Damage Model of Ductile Cast Iron Under Low-Cycle Fatigue Conditions
    Wu, Xijia
    Quan, Guangchun
    Macneil, Ryan
    Zhang, Zhong
    Sloss, Clayton
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2014, 45A (11): : 5085 - 5097
  • [2] Failure Mechanisms and Damage Model of Ductile Cast Iron Under Low-Cycle Fatigue Conditions
    Xijia Wu
    Guangchun Quan
    Ryan MacNeil
    Zhong Zhang
    Clayton Sloss
    Metallurgical and Materials Transactions A, 2014, 45 : 5085 - 5097
  • [3] Low-cycle fatigue simulation of ductile materials using elasto-plastic gradient damage approach
    Baruah, Sandipan
    Singh, Indra Vir
    INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES, 2024, 276
  • [4] LOW-CYCLE FATIGUE OF AUSTEMPERED DUCTILE IRONS
    HWANG, JR
    PERNG, CC
    SHAN, YS
    INTERNATIONAL JOURNAL OF FATIGUE, 1990, 12 (06) : 481 - 488
  • [5] Low-cycle fatigue of pearlitic ductile iron
    Harada, Shoji
    Akiniwa, Yoshiaki
    Udea, Takahiro
    Yano, Mitsuru
    Zairyo/Journal of the Society of Materials Science, Japan, 1990, 39 (443) : 1133 - 1138
  • [6] A HISTORY DEPENDENT DAMAGE MODEL FOR LOW-CYCLE FATIGUE
    LEIS, BN
    MECHANICAL ENGINEERING, 1984, 106 (09) : 118 - 118
  • [7] A NEW DAMAGE VARIABLE FOR LOW-CYCLE FATIGUE OF METALLIC MATERIALS
    CHENG, GX
    LOU, ZW
    KUANG, ZB
    ENGINEERING FRACTURE MECHANICS, 1994, 48 (02) : 281 - 287
  • [8] DAMAGE ACCUMULATION IN LOW-CYCLE FATIGUE
    RADHAKRISHNAN, VM
    ZEITSCHRIFT FUR METALLKUNDE, 1973, 64 (10): : 705 - 710
  • [9] CUMULATIVE DAMAGE IN LOW-CYCLE FATIGUE
    RADHAKRISHNAN, VM
    EXPERIMENTAL MECHANICS, 1978, 18 (08) : 292 - 296
  • [10] Damage in the complex low-cycle fatigue
    Bobyr, M.
    Yakhno, B.
    Rusinski, E.
    Harnatkiewicz, P.
    ARCHIVES OF CIVIL AND MECHANICAL ENGINEERING, 2008, 8 (03) : 23 - 31