Treatment of brominated epoxy resin waste in subcritical dimethylformamide wastewater: Upcycling of brominated epoxy resin and dimethylformamide degradation

The debromination and upcycling of brominated epoxy resin (BER) waste is important for the e-waste treatment, while the degradation and removal of N, N-dimethylformamide (DMF) is the critical step for the DMF wastewater treatment. In this study, a co-treatment strategy was proposed for the BER waste and DMF wastewater by the subcritical water process. The co-treatment was carried out using subcritical DMF wastewater (SDW) as the reaction medium. The results showed a significantly synergistic effect between the BER conversion and DMF degradation in the SDW process. The optimal reaction conditions were as follows: reaction temperature of 300 degrees C, solid-to-liquid ratio of 1:15 g/mL, DMF wastewater of 30000 mg/L and reaction time of 60 min. Under the optimal reaction conditions, the debromination ratio of the BER was 98.57 %, the degradation ratio of the DMF reached 99.59 %, and phenolic substances with a purity of 86.61 % were recovered. The formation of HBr from the debromination of the BER was the most significant factor affecting the pH of the system, which had a noticeable impact on the degradation of the DMF. The main degradation products of the DMF were dimethylamine (DMA), methylamine (MA), NH3, NH4+, and CO2. The products degraded from the DMF could significantly promote the debromination and conversion of the BER. Life cycle assessment (LCA) analysis showed that the SDW process had low CO2 emissions. It is believed that the SDW process proposed in this study is an efficient technology for the synergistic treatment of the BER waste and DMF wastewater.