Concatenated Bragg grating fiber-optic sensors for simultaneous measurement of curvature, temperature, and axial pressure

This paper presents the development and evaluation of four sensors based on multiple fiber Bragg grating (FBG) constellations embedded in a silicon dioxide single-mode fiber (SMF) for simultaneous measurement of pressure, temperature, and bending curvature. We applied dimension and material variations - including core, cladding, and coating dimensions; coating material; and the number and arrangement of the FBGs - to optimize the reflected signal response and increase information density. A bootstrap-aggregated ensemble of decision trees was used to evaluate the sensor signal. The results show that adjusting the cladding-to-coating ratio led to significant improvements in pressure and bending prediction performance. Additionally, two combined FBGs were fabricated to form a fiber Bragg grating Fabry-P & eacute;rot interferometer, which enabled the detection of curvature with a root-mean-square error (RMSE) of 0.0034 L mm-1 (R2=1), axial pressure with an RMSE of 0.0564 bar (R2=0.99), and temperature with an RMSE of 0.0265 degrees C (R2=1). At the time of writing, there is no commercially available instrument that can perform these measurements simultaneously.