Natural low corrosive phytic acid electrolytes enable green, ultrafast, stable and high-voltage aqueous proton battery

Proton is a promising charge carrier for aqueous rechargeable batteries due to its small ionic radius, fast diffusion kinetics and great abundance in nature. However, commonly-used proton battery electrolytes are strong acids, such as sulfuric acid, phosphoric acid, etc., which always leads to the notorious rapid corrosion of electrode and metal components, and thus the poor cyclability, the limited materials option and high maintenance cost. Here, we reported a new-type high-concentration phytic acid (PA) electrolytes, which exhibits marvellous superiorities including environmental friendliness, low corrosiveness, high ionic conductivity (133.3 mS cm(-1)) and wide working potential window (similar to 2.9 V) in contrast to conventional acid electrolytes. The experimental and calculation results indicated that the scarcity of free water in high-concentration PA electrolytes and the desolvation effect of the preferentially absorbed PA interfacial layer on the electrode surface work in synergy to inhibit the water activity and thus prevent electrode dissolution and side reactions. Benefiting from this, the assembled K0.2VO0.6[Fe(CN)(6)](0.8)center dot 6H(2)O (VHCF)//MoO3 button-type proton battery shows an average discharge voltage of 0.7 V with a pair of well-defined redox peak at about 1.4 V, great rate performance, excellent cycling stability (87.9% capacity retention after 1000 cycles at 5 A g(-1)) and superb coulombic efficiency at various current densities (1 A g(-1)-50 A g(-1)). Attributed to good anti-freezing properties of the electrolytes, the proton battery can also run normally at -60 degrees C and exhibit competent performance (a capacity retention of 45 mAh g(-1) at 0.1 A g(-1) after 540 cycles). Such green low corrosive electrolyte will be fully compatible with conventional battery fabrication process, and open brand new avenue for the development of aqueous proton battery.