Effect of marginal beams on the punching shear capacity of concrete slabs at exterior columns

It is common in concrete flat plate construction to connect the exterior columns with marginal, or edge, beams. In addition to the benefit gained from marginal beams in stiffening the slab edges and supporting the concentrated loads on the slab edge, they aid in resisting punching shear at the exterior columns. However, in most cases the marginal beam dimensions are limited by architectural constraints rendering it very small relative to the adjoining columns. In such cases, especially ones when the column protrudes beyond the beam width, the effect of the beam in resisting punching shear is doubtful. Most design codes do not provide a direct method for checking punching shear taking into account the effect of the beam, which might encourage designers to neglect punching shear design due to beam effect. This paper investigates the effect of marginal beams on the punching shear capacity of slabs at edge and corner columns. To the authors' knowledge, only the Australian Standards (AS3600) accounts for that case, however; the AS3600 provisions are based on studies conducted on beams with width equal to the adjoining column width, a case which is out of the scope of this paper. The results of eight experimentally tested slabs were used to verify the modeling approach used to generate the parametric study models. The test specimens chosen for verification of the numerical model represented two possible modes of failure, punching shear at the column slab interface and torsion shear failure of the marginal beam. Numerical models of 80 slabs were developed using ABAQUS software package. The study results were compared to three international code provisions, the ACI318, EC2 and ECP-203. The study concluded that the presence of a beam with width less than 80% of the column width does not eliminate the punching shear mode of failure, however; the beam increases the overall capacity of the connection by transferring part of the load directly to the column and reducing demand on two-way shear. Design guidelines are presented to check shear capacity of such connections.