Axial and bending behavior of GFRP bar-reinforced hollow-core polypropylene fiber concrete columns

被引：2
作者：
Ahmad, Habil [1 ,2 ]
Sheikh, M. Neaz [1 ]
Hadi, Muhammad N. S. [1 ]
机构：
[1] Univ Wollongong, Sch Civil Min Environm & Architectural Engn, Wollongong, NSW, Australia
[2] Univ Wah, Wah Engn Coll, Rawalpindi, Punjab, Pakistan
来源：
STRUCTURAL CONCRETE | 2024年
关键词：
columns; GFRP bars; GFRP spirals; hollow-core (HC); polypropylene fibers; reinforced concrete; MECHANICAL-PROPERTIES; GLASS; PERFORMANCE;
D O I：
10.1002/suco.202200921
中图分类号：
TU [建筑科学];
学科分类号：
0813 ;
摘要：
This study reported the axial (concentric and eccentric) and bending (four-point bending) loadings behavior of glass fiber-reinforced polymer (GFRP) bar-reinforced hollow-core polypropylene fiber concrete (HC-GFRP-PFC) columns. The confinement effect of HC-GFRP-PFC columns with different center-to-center (c/c) spacing of GFRP spirals was also investigated. Twelve hollow-core circular specimens with an outer diameter of 214 mm and an inner (circular hole) diameter of 56 mm were experimentally investigated. Four reference specimens were cast with nonfibrous (normal) concrete, whereas the remaining eight specimens were cast with polypropylene fiber (0.15% by volume of concrete) concrete. It was found that, with a similar ratio of reinforcement, the HC-GFRP-PFC specimens gained 2%-4% higher maximum load (P-Maximum) and 9%-19% higher ductility (mu) than the GFRP bar-reinforced hollow-core nonfibrous concrete (HC-GFRP-NFC) specimens under concentric axial loading and four-point bending. The HC-GFRP-PFC specimens with a 30 mm c/c spacing of the GFRP spiral gained 6%-36% higher P-Maximum and 4%-59% higher mu than the HC-GFRP-PFC specimens with a 60 mm c/c spacing of the GFRP spirals under different loading conditions.
引用
收藏
页码：658 / 677
页数：20
相关论文
共 39 条
  • [1] Experimental Investigation on the Behavior of Hollow-Core Glass Fiber-Reinforced Concrete Columns with GFRP Bars
    Ahmad, Habil
    Sheikh, M. Neaz
    Hadi, Muhammad N. S.
    [J]. JOURNAL OF COMPOSITES FOR CONSTRUCTION, 2022, 26 (02)
  • [2] Experimental investigation on the use of glass fiber reinforced polymer reinforcement in hollow-core circular concrete columns
    Ahmad, Habil
    Sheikh, M. Neaz
    Hadi, Muhammad N. S.
    [J]. STRUCTURAL CONCRETE, 2022, 23 (02) : 876 - 894
  • [3] Behavior of GFRP bar-reinforced hollow-core polypropylene fiber and glass fiber concrete columns under axial compression
    Ahmad, Habil
    Sheikh, M. Neaz
    Hadi, Muhammad N. S.
    [J]. JOURNAL OF BUILDING ENGINEERING, 2021, 44
  • [4] Hollow concrete columns: Review of structural behavior and new designs using GFRP reinforcement
    AlAjarmeh, O. S.
    Manalo, A. C.
    Benmokrane, B.
    Karunasena, K.
    Ferdous, W.
    Mendis, P.
    [J]. ENGINEERING STRUCTURES, 2020, 203
  • [5] Compressive behavior of axially loaded circular hollow concrete columns reinforced with GFRP bars and spirals
    AlAjarmeh, O. S.
    Manalo, A. C.
    Benmokrane, B.
    Karunasena, W.
    Mendis, P.
    Nguyen, K. T. Q.
    [J]. CONSTRUCTION AND BUILDING MATERIALS, 2019, 194 : 12 - 23
  • [6] Effect of Spiral Spacing and Concrete Strength on Behavior of GFRP-Reinforced Hollow Concrete Columns
    AlAjarmeh, Omar S.
    Manalo, Allan C.
    Benmokrane, Brahim
    Karunasena, Warna
    Mendis, Priyan
    [J]. JOURNAL OF COMPOSITES FOR CONSTRUCTION, 2020, 24 (01)
  • [7] Axial performance of hollow concrete columns reinforced with GFRP composite bars with different reinforcement ratios
    AlAjarmeh, Omar S.
    Manalo, Allan C.
    Benmokrane, Brahim
    Karunasena, Warna
    Mendis, Priyan
    [J]. COMPOSITE STRUCTURES, 2019, 213 : 153 - 164
  • [8] Influence of Polypropylene and Glass Fibers on Alkali-Activated Slag/Fly Ash Concrete
    Ali, Shehroze
    Sheikh, M. Neaz
    Sargeant, Mitchell
    Hadi, Muhammad N. S.
    [J]. ACI STRUCTURAL JOURNAL, 2020, 117 (04) : 183 - 192
  • [9] AS 1012.10, 2000, Determination of indirect tensile strength of concrete cylinders (Brazil or splitting test), in Australian standard
  • [10] AS 1012.11, 2000, Determination of the modulus of rupture
1234