Intersection control based on Fine-grained Phases for connected and automated vehicles

Traditional traffic signal control is one of the most widely used urban traffic control methods, due to its high efficiency, robustness, and simplicity. However, in the era of connected and automated vehicles (CAVs), it is prospective to enhance traffic control precision and achieve vehicle coordination in a more efficient manner. Focusing on an isolated intersection, this study proposes an innovative concept of Fine-grained Phase (FP) for CAV-enabled traffic control, which realizes more refined right-of-way allocation than traditional signal phases while preserving the simplicity and scalability. The development of FP jointly optimizes traffic control strategy and intersection layout design to fully utilize time -space resources, and multiple forms of FP could be generated in response to various traffic demands; meanwhile, vehicle coordination is achieved in an offline-online manner to balance solution quality and efficiency. Under the FP -based control, each lane is assigned with periodical entry time points using FP design results, then vehicles are supposed to catch up with the appropriate time points to fulfill their trips. Theoretical analyses are conducted under stationary vehicle arrival patterns, where the average delay and the intersection capacity associated with different forms of FP can be analytically acquired. For the implementation of FP -based control, we construct a general offline-online framework, consisting of an offline model that optimizes the geometry of the conflict zone at intersections and the control strategy of vehicles simultaneously, which is formulated as a mixed -integer linear programming problem, and an online FP adoption mechanism that can adapt to varying demand patterns. Under the framework, limited online computation is required, facilitating its practical real-time implementation. Simulation studies under a variety of demand settings show that FP -based control is advantageous over benchmark methods in reducing vehicle delay and also improving intersection capacity in most cases; even for cases with extremely imbalanced demands, FP -based control can admit comparable throughput, while the average delay is much smaller. In addition, results of computation time reveal that FP -based control could realize real-time implementation with negligible computation burden.