Microstructure evolution, mechanical properties and fracture behavior of Al-xSi/AZ91D bimetallic composites prepared by a compound casting

In this paper, the effect of the Si content on microstructure evolution, mechanical properties, and fracture behavior of the Al-xSi/AZ91D bimetallic composites prepared by compound casting was investigated systematically. The obtained results showed that all the Al-xSi/AZ91D bimetallic composites had a metallurgical reaction layer (MRL), whose thickness increased with increasing Si content for the hypoeutectic Al-Si/AZ91D composites, while the hypereutectic Al-Si/AZ91D composites were opposite. The MRL included eutectic layer (E layer), intermetallic compound layer (IMC layer) and transition region layer (T layer). In the IMC layer, the hypereutectic Al-Si/AZ91D composites contained some Si solid solution and flocculent Mg2 Si + Al-Mg IMCs phases not presented in the hypoeutectic Al-Si/AZ91D composites. Besides, increasing Si content, the thickness proportion of the T layer increased, forming an inconsistent preferred orientation of the MRL. The shear strengths of the Al-xSi/AZ91D bimetallic composites enhanced with increasing Si content, and the Al-15Si/AZ91D composite obtained a maximum shear strength of 58.6 MPa, which was 73.4% higher than the Al-6Si/AZ91D composite. The fractures of the AlxSi/AZ91D bimetallic composites transformed from the T layer into the E layer with the increase of the Si content. The improvement of the shear strength of the Al-xSi/AZ91D bimetallic composites was attributed to the synergistic action of the Mg2 Si particle reinforcement, the reduction of oxidizing inclusions and the ratio of Al-Mg IMCs as well as the orientation change of the MRL. (c) 2022 Chongqing University. Publishing services provided by Elsevier B.V. on behalf of KeAi Communications Co. Ltd. This is an open access article under the CC BY-NC-ND license ( http://creativecommons.org/licenses/by-nc-nd/4.0/ ) Peer review under responsibility of Chongqing University