Numerical simulation study of combined shot peening and laser shock peening on surface integrity of Ti-6Al-4V titanium alloy

Combined shot peening and laser shock peening (CSP) can introduce high surface compressive residual stress (CRS) and deep CRS layer, and reduce the high surface roughness caused by shot peening. The relationship between CSP sequences and surface integrity, including CRS and surface roughness, is far from satisfying the actual demand. In this paper, we construct a finite element model considering initial surface profile features. The experimental results agree with the simulated results. Based on the simulation results, axial and longitudinal stress wave transfer effects on surface CRS and depth CRS are investigated. Compared with shot peening (SP) and laser shock peening (LSP) alone, CSP treatment can increase CRS depth and CRS magnitude by 1060 mu m and 50 similar to 80Mpa, respectively. In addition, the roughness following CSP treatment is lower than that observed after SP treatment alone, and the roughness varies depending on the sequence of CSP treatment. Specifically, the roughness values for SP, SP + LSP, and LSP + SP are 0.938 +/- 0.031 mu m, 0.982 +/- 0.11 mu m, and 1.168 +/- 0.093 mu m, respectively. The surface morphology, hardness, and simulation results are combined to reveal the reasons for the reduction of surface roughness after CSP treatment. The changes of peaks and valleys after CSP treatment compared with single SP treatment were studied, and the variation trend of surface roughness was further explained.