New insights into the mechanism causing the loss of anti-corrosion property of superhydrophobic titanium surfaces

In this paper, we provide new insights into the mechanism causing the loss of anti-corrosion property of superhydrophobic titanium (SHP Ti) during potentiodynamic polarization (PDP) measurements. The water contact angle and sliding angle values of the SHP Ti, produced by a facile two-step process: anodizing and coating, were >160 degrees and 6 +/- 2 degrees, respectively. The anodization of Ti resulted in randomly distributed micro-clusters of TiO2-xCly covering the Ti surface homogeneously while the low surface energy organic coatings were inhomogeneous in coverage and specifically distributed over the micro-clusters alone of the anodized titanium surface. The electrochemical impedance (EIS) analysis of the SHP CP-Ti samples has shown more than an order of magnitude improvement in their barrier /polarization resistance (R-p) values at similar to 100 M Omega.cm(2) suggesting the effectiveness of the SHP coatings as a barrier against corrosion in neutral chloride environments. However, the R-p values (similar to 10 M Omega.cm(2)) of the SHP coatings obtained from the PDP analysis were an order of magnitude lower than the R-p values derived from the EIS. SHP CP-Ti samples showed dual passive range behaviour with an initial narrow passive region due to the porous anodized TiO2-xCly layer while the later stage passivity due to the barrier TiO2 layer, where the outer anodized porous TiO2-xCly layer was less effective against corrosion in neutral chloride media. Detailed analysis showed that in PDP, the sample lost its SHP because of the permeation of electrolyte into the hierarchical surface, due to its sensitivity to polarization, owing to the lower thickness of the organic layers. The mechanism involved in the loss of SHP and the limitation of the PDP technique for the corrosion analysis of SHP / organic coatings on metal surfaces is highlighted.