Experimental investigations and numerical simulations of lattice structures obtained by additive manufacturing

被引:0
作者
Remadi, Amina [1 ]
Chatti, Sami [2 ]
Belaid, Dhekra [2 ]
机构
[1] Univ Sousse, Natl Engn Sch Sousse ENISo, Mech Lab Sousse LMS, Sousse, Tunisia
[2] Higher Inst Appl Sci & Technol Sousse, Sousse 4003, Tunisia
来源
MATERIAUX & TECHNIQUES | 2024年 / 112卷 / 02期
关键词
additive manufacturing; tensile test; numerical simulations; stress distribution;
D O I
10.1051/mattech/2024011
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
In this study, both experimental and numerical investigations are carried out on samples fabricated by additive manufacturing (AM). The determination of stress distribution in parts obtained by AM, even for simple tensile test, is complicated because it is largely influenced by many manufacturing parameters as the adopted infill pattern, the infill orientation and the infill density. Firstly, the material parameters of the fused filament PLA and tensile specimens made by the AM with an infill grid pattern with density of 100% are experimentally determined. Then, the effect of the infill orientation with an infill density of 40% on the tensile stress state is experimentally and numerically investigated. By synthesizing these results, a comprehensive understanding of stress distribution in AM-produced components is achieved. The obtained anisotropic mechanical parameters are used to simulate compression of a flat-ring part.
引用
收藏
页数:8
相关论文
共 13 条
  • [11] Novel mechanical models of tensile strength and elastic property of FDM AM PLA materials: Experimental and theoretical analyses
    Zhao, Yu
    Chen, Yuansong
    Zhou, Yongjun
    [J]. MATERIALS & DESIGN, 2019, 181
  • [12] Isotropic and anisotropic elasticity and yielding of 3D printed material
    Zou, Rui
    Xia, Yang
    Liu, Shiyi
    Hu, Ping
    Hou, Wenbin
    Hu, Qingyuan
    Shan, Chunlai
    [J]. COMPOSITES PART B-ENGINEERING, 2016, 99 : 506 - 513
  • [13] Zouaoui M., 2021, Appl.Sci., V11, P50