Numerical Simulation of Hydrodynamics and Heat Transfer in a Reactor with a Fluidized Bed of Catalyst Particles in a Three-Dimensional Formulation

The hydrodynamics and heat transfer in a reactor with a fluidized bed of catalyst particles and an inert material were simulated. The particle bed (the particle density was 2350 kg/m3, and the particle diameter was 1.5 to 4 mm) was located in a distribution device which was a grid of 90 x 90 x 60 mm vertical baffles. The behavior of the liquefying medium (air) was modeled using a realizable k-epsilon turbulence model. The behavior of particles was modeled using the discrete element method (DEM). In order to reduce the slugging effect, the particles were divided into four separate horizontal layers. It was determined that with the velocity of the liquefying medium close to the minimum fluidization velocity (1 m/s), slugging fluidization is observed. At a velocity of the liquefying medium of 3 m/s, turbulent fluidization in the lowest particle layer and bubbling fluidization on subsequent particle layers are observed. With an increase in the velocity of the liquefying medium over 3 m/s, entrainment of particles is observed. It was shown that a decrease in the density of the liquefying medium from 1.205 kg/m3 to 0.383 kg/m3 when it is heated from 298 K to 923 K would not significantly affect the hydraulic resistance of the bed. Based on the obtained results, it can be stated that the obtained model is optimal for such problems and is suitable for the further description of experimental data.