DEVELOPMENT OF CYLINDER DIELECTRIC BARRIER DISCHARGE WITH STAINLESS STEEL FOR OZONE PRODUCTION

被引：0

作者：

Amri, Djulil ^{[1
]}

Fitria, Syarifa ^{[1
,2
]}

Nawawi, Zainuddin ^{[1
]}

Jambak, Muhammad Irfan ^{[1
]}

Yuniarti, Dwirina ^{[1
]}

机构：

[1] Department of Electrical Engineering, University Of Sriwijaya, Sumatera Selatan, 30662, Indonesia

[2] Department of Environmental Science, University Of Sriwijaya, Sumatera Selatan, 30662, Indonesia

来源：

Journal of Technology | 2022年 / 37卷 / 03期

关键词：

Cylinders (shapes) - Dielectric devices - Dielectric materials - Electrodes - Flow control - Ozone - Stainless steel;

D O I：

暂无

中图分类号：

学科分类号：

摘要：

This paper presents the development of dielectric barrier discharge research. In order to investigate the optimum conditions for ozone production, measurements of ozone concentration were carried out for various conditions such as type electrodes and distance density between peak to peak of the electrode. It discusses the performance of the different types of electrodes, i.e. helix and screw. This research analyzed the results obtained from two different types of electrodes while the screw-type has higher ozone concentration than the helix type. This occurred due to the influence of sharp edge effects that increases the electric field around the angle of the helix. Another effect for ozone production is peak to peak distance density on the electrode winding. The high ozone concentration is indicated by the density of the 2 mm distance from peak to peak. This development cylinder dielectric barrier discharge is able to produce ozone product at more than 2000 ppm by using 6kV. © 2022, National Taiwan University of Science and Technology. All rights reserved.

引用

页码：199 / 203