Piecewise curvature compensated bandgap reference circuit with trimming procedure

被引:0
作者
Xu C. [1 ,2 ,3 ]
Wu D. [1 ,3 ]
Li X. [1 ,3 ]
Xu D. [1 ,3 ]
Yu Y. [1 ,3 ]
Cheng X. [1 ,3 ]
机构
[1] Shanghai Institute of Microsystem and Information Technology, Chinese Academy of Sciences, Shanghai
[2] School of Physical Science and Technology, ShanghaiTech University, Shanghai
[3] University of Chinese Academy of Sciences, Beijing
来源
Harbin Gongye Daxue Xuebao/Journal of Harbin Institute of Technology | 2020年 / 52卷 / 04期
关键词
Chip-level trimming; Piecewise curvature compensated; Reference; Temperature coefficient; Trimming;
D O I
10.11918/201902037
中图分类号
学科分类号
摘要
To obtain bandgap reference voltage with high PSRR, high precision, and low temperature coefficient and meanwhile reduce the influence of non-ideal factors in the process, a piecewise curvature compensated bandgap reference circuit with a trimming procedure was proposed. The current with positive and negative temperature coefficients was generated by utilizing the resistor divider and the electrical characteristics of the MOSFET operating in the subthreshold region. The bandgap reference voltage was compensated at high temperature and low temperature respectively. A new chip-level trimming method including temperature coefficient trimming and voltage amplitude trimming for rapidly optimizing the reference voltage temperature coefficient, which can quickly acquire the code value of the lowest temperature coefficient curve and improve work efficiency. Based on 0.35 μm Bipolar-CMOS-DMOS (BCD) process, the chip was taped out to verify the feasibility of the trimming scheme. Simulation and test results show that: from -40℃ to 125℃, the lowest simulated reference voltage temperature coefficiency was 0.84×10-6/℃, the lowest measured temperature coefficiency was 5.33×10-6/℃, and the average temperature coefficiency was 7.47×10-6/℃ according to ramdom sampling. The average trimming times for ten chips was 3.5 by using the method based on calculating the slope. The efficiency was improved by 59.8% compared with the method of successive approximation. The bandgap reference voltage with low temperature coefficient is helpful to improve the accuracy of the battery management chip in estimating battery residual power. This circuit has been successfully applied to high precision analog-to-digital converter in battery management chips. © 2020, Editorial Board of Journal of Harbin Institute of Technology. All right reserved.
引用
收藏
页码:112 / 118
页数:6
相关论文
共 17 条
[1]  
Zhou Q., Cheng F., Li H., Et al., High-order curvature-compensated CMOS bandgap voltage reference, Proceedings of the 12th International Conference on ASIC, (2017)
[2]  
Yin Y., Li D., Deng H., A high precision CMOS bandgap reference with exponential curvature-compensation, Proceedings of International Conference on Anti-Counterfeiting, Security and Identification, (2013)
[3]  
Luo L., Cai X., Li Z., The design of sub-threshold reference circuit using resistor temperature, Proceedings of the 52nd IEEE International Midwest Symposium on Circuits and Systems, (2009)
[4]  
Rincon-Mora G.A., Voltage References from Diodes to Precision High-order Bandgap Circuits, (2002)
[5]  
Li Y., Sun Y., Wang X., Low-offset high-PSRR bandgap voltage reference, Journal of Xidian University, 44, 5, (2017)
[6]  
Liu X., Zhang Y., Ji Q., Et al., Design and realization of a high-precision and low temperature drift reference circuit, Journal of Xidian University (Natural Science), 46, 2, (2019)
[7]  
Wang R., Lu W., Niu Y., Et al., A 2.1-ppm/℃ current-mode CMOS bandgap reference with piecewise curvature compensation, Proceedings of International Symposium on Circuit and Systems, (2017)
[8]  
Hu J., Xu H., Zhang Y., Et al., A 1.2V supply 0.58 ppm/℃ CMOS bandgap voltage reference, IEICE Electronic Express, 15, 16, pp. 1-6, (2018)
[9]  
Akshaya R., Siva S.Y., Design of an improved bandgap reference in 180nm CMOS process technology, Proceedings of the 2nd IEEE International Conference on Recent Trends in Electronics, Information & Communication Technology (RTEICT), (2017)
[10]  
Rincon-Mora G., Allen P.E., A 1.1 V current-mode and piecewise-linear curvature-corrected bandgap reference, IEEE Journal of Solid-State Circuits, 33, 10, (1998)