Shear Strength of Concrete Block Masonry Using Direct Shear Test

This paper presents the details of experimental testing of block masonry triplets using the direct shear test to investigate the shear behaviors of block unit-mortar interfaces. Hollow blocks of 100 and 150 mm (4 and 6 in.) thickness and solid blocks of 100 mm (4 in.) thickness were included in the testing program. These were combined with mortars of three grades to cast a total of 84 triplets. In addition to testing the triplets in an unconfined state, three increasing levels of precompression stresses were used separately to test the confined specimens. The shear behaviors of the tested triplets were not influenced by block strength, while shear strength increased (almost) linearly with mortar strength. The mean peak shear stress for the unconfined triplets was 0.4 MPa (58 psi), whereas the average shear modulus of the joint for these triplets was 6.20 times the mortar compressive strength. The Mode II fracture energy of the masonry joints increased at higher precompression levels. The methods of determining shear strength, shear modulus, and shear strength parameters for the mortar joint in block masonry are proposed using the observed data.