Design of solder connections for self-assembly of optoelectronic devices

In surface mount assembly, advantage is taken of the high surface tension of molten solder to self-align ball grid array packages and flip chip die. However, in these applications, the volume of solder applied as paste by stencil printing is not sufficiently well controlled to achieve the precise alignment required for optoelectronic devices. We believe that the requirement on solder volume control for assembly of optoelectronic devices can be relaxed by designing the bond pads so that the height or alignment of connections is controlled by the surface tension of the solder rather than its volume. Our design approach to accomplishing this is to connect auxiliary pads to the primary attachment pad, which act as solder reservoirs. Surface tension causes the solder to be redistributed among these pads to achieve a uniform pressure throughout the solder volume. This phenomena is governed by the Young-Laplace equation, DP 5 gk, in which DP represents the difference in pressure within and outside the solder, g the surface tension of the solder, and k the local curvature of the solder surface. Thus, the design of the set of primary and auxiliary pads is critically important to realizing the desired control of joint height. In this article, we describe the use of the Surface Evolver software package in combination with analytical models, to analyze the behavior of various connection configurations with respect to variations in printed solder volume. Specifically, we calculate the equilibrium shape of the solder surface over the connected set of pads and examine how control of joint height is affected by the number, size, and geometry of auxiliary pad configurations. © 2019 International Microelectronics Assembly and Packaging Society.