Environmentally-assisted cracking of electropolished 316L stainless steel in molten FLiNaK salt

Environmentally-assisted cracking is a well-known and extensively studied phenomenon in light water reactor environments but remains relatively unexplored in proposed molten salt reactor systems where the mechanisms at play are expected to be quite different. Here, slow strain rate testing has been performed on 316L stainless steel tensile specimens during simultaneous exposure to a molten LiF-KF-NaF eutectic salt environment at 600 degrees C with a strain rate between 1E-5 to 1E-7 s -1 . Sample ductility and ultimate tensile strength were both observed to decrease for slower strain rates/longer salt exposures. Post -mortem characterization of fractured specimens revealed Fe deposits and Cr- and O-rich precipitates decorating surface grain boundaries and crack surfaces, suggesting a cracking mechanism driven by embrittlement of the crack tip due to oxide formation. Unlike previous studies, intergranular Cr corrosion into the bulk was not observed, and distinct differences in surface morphology between electropolished and non-electropolished sample surfaces are reported. Trace metal salt chemistry measurements showed accumulation of 316L alloying elements over the course of the tests. It appears likely that the surface oxide layer induced by electropolishing, in addition to oxygen and moisture impurities in the salt, led to the formation of LiCrO 2 which had a net passivating effect that prevented significant bulk corrosion, though some interplay between mechanical and environmental stressors is still observed.