Efficient optimization of fracturing parameters with consideration of fracture propagation and heterogeneity in tight gas reservoirs

The parameters of fractures, such as fracture geometries, placement, and conductivity, are critical for the production of horizontal wells in tight gas reservoirs. Current studies on fracture parameter optimization, especially those using the optimization algorithms, are often based on the assumptions that the fractures are uniformly placed with equal length and conductivity. However, non -uniform designs of fracture spacing have been proved to be effective in reducing fracture interference as well as increasing the well production, especially with strong rock heterogeneity. In addition, most of the current literature focuses on identifying optimal hydraulic fracture geometries without considering the fracture propagation process, which may oversimplify the evaluation of completion cost and result in fracture geometries that cannot be realized in practice. In this paper, an automatic optimization process, which could efficiently couple the fracture propagation, is proposed to optimize the fracture parameters. The genetic algorithm (GA) with penalty function method is used to optimize the constraint and non-linear problem. A modified PKN fracture propagation model is established to quickly predict the hydraulic fracture geometries. Fracture locations and fluid injection volume are sequentially optimized with consideration of heterogeneous rock properties. Model parameters are taken from typical tight gas horizontal wells in Jinqiu gas field in Sichuan Province, China. The results show the importance of permeability on both fracture length and production in tight gas well. The lower the permeability, the more significant the production increase after fracture location optimization. More fractures tend to be placed in area with small permeability and fewer fractures are required in highly permeable regions. With an increase in rock heterogeneity, the distribution of fractures becomes more uneven. Conversely, increasing the number of fractures can lead to a more even distribution of fractures. More fluid should be injected in low -permeability regions according to the optimization results. The optimization method is applied to a practical tight gas well in Sichuan Basin and the cumulative gas production can be increased by 6.5% to 8% when compared with the initial uniform designs.